On Mon, 22 Oct 2018 11:43:40 +0000 Yogesh Narayan Gaur <yogeshnarayan.g...@nxp.com> wrote:
> + Mark Brown > > Complete patch series[1] > [1] https://patchwork.ozlabs.org/project/linux-mtd/list/?series=70210 Please resend the patch series with a "PATCH RESEND v4" prefix and explain why you resend it in the cover letter. > > -- > Regards, > Yogesh Gaur > > > -----Original Message----- > > From: Yogesh Narayan Gaur [mailto:yogeshnarayan.g...@nxp.com] > > Sent: Thursday, October 11, 2018 4:30 PM > > To: linux-...@lists.infradead.org; boris.brezil...@bootlin.com; > > marek.va...@gmail.com; linux-...@vger.kernel.org; > > devicet...@vger.kernel.org > > Cc: r...@kernel.org; mark.rutl...@arm.com; shawn...@kernel.org; linux- > > arm-ker...@lists.infradead.org; computersforpe...@gmail.com; > > frieder.schre...@exceet.de; linux-kernel@vger.kernel.org; Yogesh Narayan > > Gaur <yogeshnarayan.g...@nxp.com> > > Subject: [PATCH v4 0/5] spi: spi-mem: Add driver for NXP FlexSPI controller > > > > - Add driver for NXP FlexSPI host controller > > > > FlexSPI is a flexsible SPI host controller [1], Chapter 30 page 1475, > > which > > supports two SPI channels and up to 4 external devices. > > Each channel supports Single/Dual/Quad/Octal mode data transfer (1/2/4/8 > > bidirectional data lines) i.e. FlexSPI acts as an interface to external > > devices, > > maximum 4, each with up to 8 bidirectional data lines. > > > > - Tested this driver with mtd_debug(Erase/Write/Read) utility and JFFS2 > > filesystem mounting and booting on NXP LX2160ARDB[2] and LX2160AQDS > > targets. > > LX2160ARDB is having two NOR slave device connected on single bus A i.e. > > A0 > > and A1 (CS0 and CS1). > > LX2160AQDS is having two NOR slave device connected on separate buses one > > flash on A0 and second on B1 i.e. (CS0 and CS3). > > Verified this driver on following SPI NOR flashes: > > Micron, mt35xu512aba[3], [Read - 1 bit mode] > > Cypress, s25fl512s, [Read - 1/2/4 bit mode] > > > > [1] https://www.nxp.com/docs/en/reference-manual/IMXRT1050RM.pdf > > [2] https://patchwork.kernel.org/project/linux-arm-kernel/list/?series=26689 > > [3] https://patchwork.ozlabs.org/project/linux-mtd/list/?series=70179 > > > > Yogesh Gaur (5): > > spi: spi-mem: Add driver for NXP FlexSPI controller > > dt-bindings: spi: add binding file for NXP FlexSPI controller > > arm64: dts: lx2160a: add FlexSPI node property > > arm64: defconfig: enable NXP FlexSPI driver > > MAINTAINERS: add maintainers for the NXP FlexSPI driver > > > > Changes for v4: > > - Incorporated review comments for > > patch 'spi: spi-mem: Add driver for NXP FlexSPI controller'. > > - Incorporated binding file review comments. > > Changes for v3: > > - Incorporated review comments for > > patch 'spi: spi-mem: Add driver for NXP FlexSPI controller'. > > Changes for v2: > > - Incorporated Boris review comments and drop below patches as per the > > comments. > > - Patch 'spi: add slave device size in spi_device struct' > > - Patch 'spi: add flags for octal I/O data transfer' > > - Incorporated DTS and Binding file review comments of Shawn Guo and Rob > > Herring. > > > > .../devicetree/bindings/spi/spi-nxp-fspi.txt | 39 + > > MAINTAINERS | 6 + > > arch/arm64/boot/dts/freescale/fsl-lx2160a-rdb.dts | 22 + > > arch/arm64/boot/dts/freescale/fsl-lx2160a.dtsi | 12 + > > arch/arm64/configs/defconfig | 1 + > > drivers/spi/Kconfig | 10 + > > drivers/spi/Makefile | 1 + > > drivers/spi/spi-nxp-fspi.c | 1158 > > ++++++++++++++++++++ > > 8 files changed, 1249 insertions(+) > > create mode 100644 Documentation/devicetree/bindings/spi/spi-nxp-fspi.txt > > create mode 100644 drivers/spi/spi-nxp-fspi.c > > > > -- > > 2.7.4 >