Hi Kishon, On 20/11/18 10:23 AM, Kishon Vijay Abraham I wrote: > Hi, > > On 19/11/18 4:46 PM, Faiz Abbas wrote: >> Commit 7d33c3581536 ("mmc: sdhci-omap: Workaround for Errata i802") >> disabled DCRC interrupts during tuning. This write to the interrupt >> enable register gets overwritten in sdhci_prepare_data() and the >> interrupt is not in fact disabled. Fix this by disabling the interrupt >> in the host->ier variable. >> >> Signed-off-by: Faiz Abbas <faiz_ab...@ti.com> >> --- >> drivers/mmc/host/sdhci-omap.c | 7 +++---- >> 1 file changed, 3 insertions(+), 4 deletions(-) >> >> diff --git a/drivers/mmc/host/sdhci-omap.c >> b/drivers/mmc/host/sdhci-omap.c >> index 88347ce78f23..87138067e334 100644 >> --- a/drivers/mmc/host/sdhci-omap.c >> +++ b/drivers/mmc/host/sdhci-omap.c >> @@ -290,7 +290,6 @@ static int sdhci_omap_execute_tuning(struct >> mmc_host *mmc, u32 opcode) >> u32 start_window = 0, max_window = 0; >> u8 cur_match, prev_match = 0; >> u32 length = 0, max_len = 0; >> - u32 ier = host->ier; >> u32 phase_delay = 0; >> int ret = 0; >> u32 reg; >> @@ -317,9 +316,7 @@ static int sdhci_omap_execute_tuning(struct >> mmc_host *mmc, u32 opcode) >> * during the tuning procedure. So disable it during the >> * tuning procedure. >> */ >> - ier &= ~SDHCI_INT_DATA_CRC; >> - sdhci_writel(host, ier, SDHCI_INT_ENABLE); >> - sdhci_writel(host, ier, SDHCI_SIGNAL_ENABLE); >> + host->ier &= ~SDHCI_INT_DATA_CRC; >> while (phase_delay <= MAX_PHASE_DELAY) { >> sdhci_omap_set_dll(omap_host, phase_delay); >> @@ -366,6 +363,8 @@ static int sdhci_omap_execute_tuning(struct >> mmc_host *mmc, u32 opcode) >> ret: >> sdhci_reset(host, SDHCI_RESET_CMD | SDHCI_RESET_DATA); >> + /* Reenable forbidden interrupt */ >> + host->ier |= SDHCI_INT_DATA_CRC; > > It's better to have a backup of host->ier and restore the value here (in > case DATA_CRC is disabled for other cases). >
host->ier is modified everywhere during an mmc request. I would not expect it to hold its value after so many tuning commands. I can add a bool to check of DCRC was enabled before and only then re-enable it. Thanks, Faiz