Hi Vokáč,
On Tue, Dec 18, 2018 at 12:42 PM Vokáč Michal <michal.vo...@ysoft.com> wrote:
> +&fec {
> + pinctrl-names = "default";
> + pinctrl-0 = <&pinctrl_enet>;
> + phy-mode = "rgmii-id";
> + phy-reset-gpios = <&gpio1 25 GPIO_ACTIVE_HIGH>;
Are you sure this is active high?
The FEC driver ignores the polarity of phy-reset-gpios and it assumes
the GPIO reset as active low.
If it really is active high, then you would need to pass the
"phy-reset-active-high" property.
> +/ {
> + model = "Y Soft IOTA Draco i.MX6Solo board";
> + compatible = "ysoft,imx6dl-yapp4-draco", "fsl,imx6dl";
> +
> + cpus {
> + /delete-node/ cpu@1;
Is this really needed? We don't usually do this on imx6solo dts board files.
Only one CPU will be brought up online on imx6solo anyway.
> + };
> +
> + memory@10000000 {
Need to pass "device_type = "memory";"
> +/ {
> + model = "Y Soft IOTA Hydra i.MX6DualLite board";
> + compatible = "ysoft,imx6dl-yapp4-hydra", "fsl,imx6dl";
> +
> + memory@10000000 {
Need to pass "device_type = "memory";"
> + memory@10000000 {
Need to pass "device_type = "memory";"
