On Fri, 18 Jan 2019, Ran Wang wrote: > Hi Alan, > > On January 18, 2019 00:08, Alan Stern wrote: > > > > On Thu, 17 Jan 2019, Ran Wang wrote: > > > > > arm/arm64's io.h doesn't define clrbits32() and clrsetbits_be32(), > > > which causing compile failure on some Layerscape Platforms (such as > > > LS1021A and LS2012A which also integrates FSL EHCI controller). So use > > > ioread32be()/iowrite32be() instead to make it workable on both powerpc > > > and arm. > > > > For patches 1/3 and 3/3: > > > > Acked-by: Alan Stern <st...@rowland.harvard.edu> > > > > Have you tested these on the Layerscape platforms to make sure they work > > correctly? > > To be honest, the first goal of this patch set is to fix compile issue. > And I have verified it on LS1012AQDS, and encountered failure as below: > > [ 2.966755] ehci-fsl: Freescale EHCI Host controller driver > [ 2.973113] fsl-ehci fsl-ehci.0: Freescale On-Chip EHCI Host Controller > [ 2.979851] fsl-ehci fsl-ehci.0: new USB bus registered, assigned bus > number 3 > [ 2.987549] fsl-ehci fsl-ehci.0: irq 22, io mem 0x08600000 > [ 3.005769] fsl-ehci fsl-ehci.0: USB 2.0 started, EHCI 0.00 > [ 3.012122] hub 3-0:1.0: USB hub found > [ 3.016088] hub 3-0:1.0: config failed, hub doesn't have any ports! (err > -19) > > However, actually the only board which I can find so far has known HW issue on > EHCI part, so I plan to find other platform to do complete verification when > possible. And will submit other fix if needed. Is that OK? > > BTW, for powerpc platform, I've tested on a T1042AD4RDB and USB worked fine > with it.
Okay, that's good. Alan Stern
