If the SPI slave requires an inter-word delay, configure the DLYBCT
register accordingly.
Tested on a SAMA5D2 board (derived from SAMA5D2-Xplained reference
board).
Signed-off-by: Jonas Bonn <jo...@norrbonn.se>
Acked-by: Nicolas Ferre <nicolas.fe...@microchip.com>
CC: Nicolas Ferre <nicolas.fe...@microchip.com>
CC: Mark Brown <broo...@kernel.org>
CC: Alexandre Belloni <alexandre.bell...@bootlin.com>
CC: Ludovic Desroches <ludovic.desroc...@microchip.com>
CC: linux-...@vger.kernel.org
CC: linux-arm-ker...@lists.infradead.org
---
drivers/spi/spi-atmel.c | 11 ++++++-----
1 file changed, 6 insertions(+), 5 deletions(-)
diff --git a/drivers/spi/spi-atmel.c b/drivers/spi/spi-atmel.c
index f53f0c5e63da..4954f0ab1606 100644
--- a/drivers/spi/spi-atmel.c
+++ b/drivers/spi/spi-atmel.c
@@ -1201,13 +1201,14 @@ static int atmel_spi_setup(struct spi_device *spi)
csr |= SPI_BIT(CSAAT);
/* DLYBS is mostly irrelevant since we manage chipselect using GPIOs.
- *
- * DLYBCT would add delays between words, slowing down transfers.
- * It could potentially be useful to cope with DMA bottlenecks, but
- * in those cases it's probably best to just use a lower bitrate.
*/
csr |= SPI_BF(DLYBS, 0);
- csr |= SPI_BF(DLYBCT, 0);
+
+ /* DLYBCT adds delays between words. This is useful for slow devices
+ * that need a bit of time to setup the next transfer.
+ */
+ csr |= SPI_BF(DLYBCT,
+ (as->spi_clk / 1000000 * spi->word_delay_usecs) >> 5);
asd = spi->controller_state;
if (!asd) {
--
2.19.1
