08.02.2019 0:47, Sowjanya Komatineni пишет:
> This patch adds I2C interface timing registers support for
> proper bus rate configuration along with meeting the I2C spec
> setup and hold times based on the tuning performed on Tegra210,
> Tegra186 and Tegra194 platforms.
>
> I2C_INTERFACE_TIMING_0 register contains TLOW and THIGH field
> and Tegra I2C controller design uses them as a part of internal
> clock divisor.
>
> I2C_INTERFACE_TIMING_1 register contains the setup and hold times
> for start and stop conditions.
>
> Acked-by: Thierry Reding <tred...@nvidia.com>
> Signed-off-by: Sowjanya Komatineni <skomatin...@nvidia.com>
> ---
[snip]
>
> + if (i2c_dev->bus_clk_rate > I2C_STANDARD_MODE &&
> + i2c_dev->bus_clk_rate <= I2C_FAST_PLUS_MODE) {
> + tlow = i2c_dev->hw->tlow_fast_fastplus_mode;
> + thigh = i2c_dev->hw->thigh_fast_fastplus_mode;
> + tsu_thd = i2c_dev->hw->setup_hold_time_fast_fast_plus_mode;
> + } else {
> + tlow = i2c_dev->hw->tlow_std_mode;
> + thigh = i2c_dev->hw->thigh_std_mode;
> + tsu_thd = i2c_dev->hw->setup_hold_time_std_mode;
> + }
> +
> + if (i2c_dev->hw->has_interface_timing_reg && val) {
Shouldn't it be "&& tlow"?
> + val = (thigh << I2C_THIGH_SHIFT) | tlow;
> + i2c_writel(i2c_dev, val, I2C_INTERFACE_TIMING_0);
> + }
> +
> + if (i2c_dev->hw->has_interface_timing_reg && tsu_thd)
> + i2c_writel(i2c_dev, tsu_thd, I2C_INTERFACE_TIMING_1);
Do we really need those "&& tlow" and "&& tsu_thd" at all? It looks to me that
checking for "has_interface_timing_reg" should be enough.
