Hi Sugaya, thanks for your patch!
On Fri, Feb 8, 2019 at 1:32 PM Sugaya Taichi <[email protected]> wrote: > Add DT bindings document for Milbeaut M10V pinctrl. > > Signed-off-by: Sugaya Taichi <[email protected]> (...) > +- interrupts: three interrupts specifer. > +- interrupt-names: corresponds "interrupts" factor. (...) > + interrupts = <0 54 4>, <0 55 4>, <0 56 4>, <0 57 4>, > + <0 58 4>, <0 59 4>, <0 60 4>, <0 61 4>, > + <0 62 4>, <0 63 4>, <0 64 4>, <0 65 4>, > + <0 66 4>, <0 67 4>, <0 68 4>, <0 69 4>; > + interrupt-names = "pin-48", "pin-49", "pin-50", "pin-51", > + "pin-52", "pin-53", "pin-54", "pin-55", > + "pin-56", "pin-57", "pin-58", "pin-59", > + "pin-60", "pin-61", "pin-62", "pin-63"; As mentioned in the review of the driver, don't do this. This is a hierarchical interrupt controller, so these GIC-offset-to-GPIO-interrupt-offests should be hardcoded in the driver. If these interrupt offsets differ between difference instances of this pin controller, they should have different compatible strings. Yours, Linus Walleij
