Hello,
Any comments on this patch?
Thanks
Phil
> -----Original Message-----
> From: Phil Edworthy <phil.edwor...@renesas.com>
> Sent: 13 November 2018 13:09
> To: Marc Zyngier <marc.zyng...@arm.com>; Thomas Gleixner
> <t...@linutronix.de>; Jason Cooper <ja...@lakedaemon.net>
> Cc: Geert Uytterhoeven <ge...@linux-m68k.org>; linux-renesas-
> s...@vger.kernel.org; linux-kernel@vger.kernel.org; Phil Edworthy
> <phil.edwor...@renesas.com>
> Subject: [PATCH v3 2/2] irqchip: Add support for Renesas RZ/N1 GPIO
> interrupt multiplexer
>
> On RZ/N1 devices, there are 3 Synopsys DesignWare GPIO blocks each
> configured to have 32 interrupt outputs, so we have a total of 96 GPIO
> interrupts. All of these are passed to the GPIO IRQ Muxer, which selects
> 8 of the GPIO interrupts to pass onto the GIC. The interrupt signals aren't
> latched, so there is nothing to do in this driver when an interrupt is
> received,
> other than tell the corresponding GPIO block.
>
> Signed-off-by: Phil Edworthy <phil.edwor...@renesas.com>
> ---
> v3:
> - Use 'interrupt-map' DT property to map the interrupts, this is very similar
> to PCIe MSI. The only difference is that we need to get hold of the
> interrupt
> specifier for the interupts coming into the irqmux.
> - Do not use a chained interrupt controller.
> v2:
> - Use interrupt-map to allow the GPIO controller info to be specified
> as part of the irq.
> - Renamed struct and funcs from 'girq' to a more comprehenisble 'irqmux'.
> ---
> drivers/irqchip/Kconfig | 9 ++
> drivers/irqchip/Makefile | 1 +
> drivers/irqchip/rzn1-irq-mux.c | 205
> +++++++++++++++++++++++++++++++++
> 3 files changed, 215 insertions(+)
> create mode 100644 drivers/irqchip/rzn1-irq-mux.c
>
> diff --git a/drivers/irqchip/Kconfig b/drivers/irqchip/Kconfig index
> 96451b581452..53c54bba1dd8 100644
> --- a/drivers/irqchip/Kconfig
> +++ b/drivers/irqchip/Kconfig
> @@ -204,6 +204,15 @@ config RENESAS_IRQC
> select GENERIC_IRQ_CHIP
> select IRQ_DOMAIN
>
> +config RENESAS_RZN1_IRQ_MUX
> + bool "Renesas RZ/N1 GPIO IRQ multiplexer support"
> + depends on ARCH_RZN1
> + select IRQ_DOMAIN
> + help
> + Say yes here to add support for the GPIO IRQ multiplexer
> embedded
> + in Renesas RZ/N1 SoC devices. The GPIO IRQ Muxer selects which of
> + the interrupts coming from the GPIO controllers are used.
> +
> config ST_IRQCHIP
> bool
> select REGMAP
> diff --git a/drivers/irqchip/Makefile b/drivers/irqchip/Makefile index
> b822199445ff..b090f84dd42e 100644
> --- a/drivers/irqchip/Makefile
> +++ b/drivers/irqchip/Makefile
> @@ -45,6 +45,7 @@ obj-$(CONFIG_SIRF_IRQ) += irq-
> sirfsoc.o
> obj-$(CONFIG_JCORE_AIC) += irq-jcore-aic.o
> obj-$(CONFIG_RENESAS_INTC_IRQPIN) += irq-renesas-intc-irqpin.o
> obj-$(CONFIG_RENESAS_IRQC) += irq-renesas-irqc.o
> +obj-$(CONFIG_RENESAS_RZN1_IRQ_MUX) += rzn1-irq-mux.o
> obj-$(CONFIG_VERSATILE_FPGA_IRQ) += irq-versatile-fpga.o
> obj-$(CONFIG_ARCH_NSPIRE) += irq-zevio.o
> obj-$(CONFIG_ARCH_VT8500) += irq-vt8500.o
> diff --git a/drivers/irqchip/rzn1-irq-mux.c b/drivers/irqchip/rzn1-irq-mux.c
> new file mode 100644 index 000000000000..ee7810b9b3f3
> --- /dev/null
> +++ b/drivers/irqchip/rzn1-irq-mux.c
> @@ -0,0 +1,205 @@
> +// SPDX-License-Identifier: GPL-2.0
> +/*
> + * RZ/N1 GPIO Interrupt Multiplexer
> + *
> + * Copyright (C) 2018 Renesas Electronics Europe Limited
> + *
> + * On RZ/N1 devices, there are 3 Synopsys DesignWare GPIO blocks each
> +configured
> + * to have 32 interrupt outputs, so we have a total of 96 GPIO interrupts.
> + * All of these are passed to the GPIO IRQ Muxer, which selects 8 of
> +the GPIO
> + * interrupts to pass onto the GIC.
> + */
> +
> +#include <linux/interrupt.h>
> +#include <linux/irq.h>
> +#include <linux/irqdomain.h>
> +#include <linux/kernel.h>
> +#include <linux/module.h>
> +#include <linux/of_irq.h>
> +#include <linux/of_platform.h>
> +
> +#define MAX_NR_INPUT_IRQS 96
> +#define MAX_NR_OUTPUT_IRQS 8
> +
> +/*
> + * "interrupt-map" consists of 1 interrupt cell, 0 address cells,
> +phandle to
> + * interrupt parent, and parent interrupt specifier (3 cells for GIC),
> +giving
> + * a total of 5 cells.
> + */
> +#define IMAP_LENGTH 5
> +
> +struct irqmux_priv;
> +struct irqmux_one {
> + unsigned int irq;
> + unsigned int src_hwirq;
> + struct irqmux_priv *priv;
> +};
> +
> +struct irqmux_priv {
> + struct device *dev;
> + struct irq_domain *irq_domain;
> + unsigned int nr_irqs;
> + struct irqmux_one mux[MAX_NR_OUTPUT_IRQS]; };
> +
> +static irqreturn_t irqmux_handler(int irq, void *data) {
> + struct irqmux_one *mux = data;
> + struct irqmux_priv *priv = mux->priv;
> + unsigned int virq;
> +
> + virq = irq_find_mapping(priv->irq_domain, mux->src_hwirq);
> +
> + generic_handle_irq(virq);
> +
> + return IRQ_HANDLED;
> +}
> +
> +static int irqmux_domain_map(struct irq_domain *h, unsigned int irq,
> + irq_hw_number_t hwirq)
> +{
> + irq_set_chip_data(irq, h->host_data);
> + irq_set_chip_and_handler(irq, &dummy_irq_chip,
> handle_simple_irq);
> +
> + return 0;
> +}
> +
> +static const struct irq_domain_ops irqmux_domain_ops = {
> + .map = irqmux_domain_map,
> +};
> +
> +static int irqmux_probe(struct platform_device *pdev) {
> + struct device *dev = &pdev->dev;
> + struct device_node *np = dev->of_node;
> + struct resource *res;
> + u32 __iomem *regs;
> + struct irqmux_priv *priv;
> + unsigned int i;
> + int nr_irqs;
> + int ret;
> + const __be32 *imap;
> + int imaplen;
> +
> + priv = devm_kzalloc(dev, sizeof(*priv), GFP_KERNEL);
> + if (!priv)
> + return -ENOMEM;
> +
> + priv->dev = dev;
> + platform_set_drvdata(pdev, priv);
> +
> + res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
> + regs = devm_ioremap_resource(dev, res);
> + if (IS_ERR(regs))
> + return PTR_ERR(regs);
> +
> + nr_irqs = of_irq_count(np);
> + if (nr_irqs < 0)
> + return nr_irqs;
> +
> + if (nr_irqs > MAX_NR_OUTPUT_IRQS) {
> + dev_err(dev, "too many output interrupts\n");
> + return -ENOENT;
> + }
> +
> + priv->nr_irqs = nr_irqs;
> +
> + /* Look for the interrupt-map */
> + imap = of_get_property(np, "interrupt-map", &imaplen);
> + if (!imap)
> + return -ENOENT;
> + imaplen /= IMAP_LENGTH * sizeof(__be32);
> +
> + /* Sometimes not all muxs are used */
> + if (imaplen < priv->nr_irqs)
> + priv->nr_irqs = imaplen;
> +
> + /* Create IRQ domain for the interrupts coming from the GPIO blocks
> */
> + priv->irq_domain = irq_domain_add_linear(np,
> MAX_NR_INPUT_IRQS,
> + &irqmux_domain_ops, priv);
> + if (!priv->irq_domain)
> + return -ENOMEM;
> +
> + for (i = 0; i < MAX_NR_INPUT_IRQS; i++)
> + irq_create_mapping(priv->irq_domain, i);
> +
> + for (i = 0; i < priv->nr_irqs; i++) {
> + struct irqmux_one *mux = &priv->mux[i];
> +
> + ret = irq_of_parse_and_map(np, i);
> + if (ret < 0) {
> + ret = -ENOENT;
> + goto err;
> + }
> +
> + mux->irq = ret;
> + mux->priv = priv;
> +
> + /*
> + * We need the first cell of the interrupt-map to configure
> + * the hardware.
> + */
> + mux->src_hwirq = be32_to_cpu(*imap);
> + imap += IMAP_LENGTH;
> +
> + dev_info(dev, "%u: %u mapped irq %u\n", i, mux-
> >src_hwirq,
> + mux->irq);
> +
> + ret = devm_request_irq(dev, mux->irq, irqmux_handler,
> + IRQF_SHARED | IRQF_NO_THREAD,
> + "irqmux", mux);
> + if (ret < 0) {
> + dev_err(dev, "failed to request IRQ: %d\n", ret);
> + goto err;
> + }
> +
> + /* Set up the hardware to pass the interrupt through */
> + writel(mux->src_hwirq, ®s[i]);
> + }
> +
> + dev_info(dev, "probed, %d gpio interrupts\n", priv->nr_irqs);
> +
> + return 0;
> +
> +err:
> + while (i--)
> + irq_dispose_mapping(priv->mux[i].irq);
> + irq_domain_remove(priv->irq_domain);
> +
> + return ret;
> +}
> +
> +static int irqmux_remove(struct platform_device *pdev) {
> + struct irqmux_priv *priv = platform_get_drvdata(pdev);
> + unsigned int i;
> +
> + for (i = 0; i < priv->nr_irqs; i++)
> + irq_dispose_mapping(priv->mux[i].irq);
> + irq_domain_remove(priv->irq_domain);
> +
> + return 0;
> +}
> +
> +static const struct of_device_id irqmux_match[] = {
> + { .compatible = "renesas,rzn1-gpioirqmux", },
> + { /* sentinel */ },
> +};
> +
> +MODULE_DEVICE_TABLE(of, irqmux_match);
> +
> +static struct platform_driver irqmux_driver = {
> + .driver = {
> + .name = "gpio_irq_mux",
> + .owner = THIS_MODULE,
> + .of_match_table = irqmux_match,
> + },
> + .probe = irqmux_probe,
> + .remove = irqmux_remove,
> +};
> +
> +module_platform_driver(irqmux_driver);
> +
> +MODULE_DESCRIPTION("Renesas RZ/N1 GPIO IRQ Multiplexer Driver");
> +MODULE_AUTHOR("Phil Edworthy <phil.edwor...@renesas.com>");
> +MODULE_LICENSE("GPL v2");
> --
> 2.17.1
