> From: Anson Huang
> Sent: Wednesday, February 20, 2019 2:54 PM
>
> NXP i.MX8QXP is an ARMv8 SoC with a Cortex-M4 core inside as system
> controller, the system controller is in charge of system power, clock and
> thermal sensors etc. management, Linux kernel has to communicate with
> system controller via MU (message unit) IPC to get temperature from thermal
> sensors, this patch adds binding doc for i.MX system controller thermal
> driver.
>
> Signed-off-by: Anson Huang <anson.hu...@nxp.com>
> Reviewed-by: Rob Herring <r...@kernel.org>
> ---
> Changes since V6:
> - put "imx,sensor-resource-id" property in thermal zone nodes.
> ---
> .../devicetree/bindings/arm/freescale/fsl,scu.txt | 27
> ++++++++++++++++++++++
> 1 file changed, 27 insertions(+)
>
> diff --git a/Documentation/devicetree/bindings/arm/freescale/fsl,scu.txt
> b/Documentation/devicetree/bindings/arm/freescale/fsl,scu.txt
> index 72d481c..ad96881 100644
> --- a/Documentation/devicetree/bindings/arm/freescale/fsl,scu.txt
> +++ b/Documentation/devicetree/bindings/arm/freescale/fsl,scu.txt
> @@ -122,6 +122,27 @@ RTC bindings based on SCU Message Protocol
> Required properties:
> - compatible: should be "fsl,imx8qxp-sc-rtc";
>
> +Thermal bindings based on SCU Message Protocol
> +------------------------------------------------------------
> +
> +Required properties:
> +- compatible : Must be "fsl,imx-sc-thermal";
> +- tsens-num : Total number of thermal sensors supported;
We properly don't need this property if the number of sensor
is fixed on a specific SoC.
> +- #thermal-sensor-cells : Should be 1. See
> + Documentation/devicetree/bindings/thermal/thermal.txt
> + for a description.
> +
> +Required properties for thermal zone nodes:
> +- imx,sensor-resource-id : This property should be defined in each thermal
After a further looking at it, I wonder this property may not needed either.
> zone
> + of thermal-zones node, it passes each thermal zone's
> + resource id for thermal driver to get temperature via
> + SCU IPC.
> +
> + For thermal zone nodes, please refer to below binding
> + doc for details:
> +
> +[1] Documentation/devicetree/bindings/thermal/thermal.txt
> +
> Example (imx8qxp):
> -------------
> lsio_mu1: mailbox@5d1c0000 {
> @@ -168,6 +189,12 @@ firmware {
> rtc: rtc {
> compatible = "fsl,imx8qxp-sc-rtc";
> };
> +
> + tsens: thermal-sensor {
> + compatible = "fsl,imx8qxp-sc-thermal";
> + tsens-num = <1>;
> + #thermal-sensor-cells = <1>;
This looks may not correct if sensor cells is 1 but the sensor number
Is also 1.
So we probably better remove tsens-num property.
Regards
Dong Aisheng
> + };
> };
> };
>
> --
> 2.7.4
