Hi Anand,
On 2019-02-22 11:19, Anand Moon wrote:
> Add Read Strobe RDQS pin configuration for eMMC to support higher data rate
> read/write.
>
> Signed-off-by: Anand Moon <[email protected]>
> ---
> arch/arm/boot/dts/exynos5420-pinctrl.dtsi | 6 ++++++
> arch/arm/boot/dts/exynos5422-odroidxu3-common.dtsi | 2 +-
> 2 files changed, 7 insertions(+), 1 deletion(-)
>
> diff --git a/arch/arm/boot/dts/exynos5420-pinctrl.dtsi
> b/arch/arm/boot/dts/exynos5420-pinctrl.dtsi
> index b82af7c89654..4fb3865e082a 100644
> --- a/arch/arm/boot/dts/exynos5420-pinctrl.dtsi
> +++ b/arch/arm/boot/dts/exynos5420-pinctrl.dtsi
> @@ -206,6 +206,12 @@
> samsung,pin-drv = <EXYNOS5420_PIN_DRV_LV4>;
> };
>
> + sd0_rdqs: sd0-rdqs {
> + samsung,pins = "gpc0-7";
> + samsung,pin-function = <EXYNOS_PIN_FUNC_2>;
> + samsung,pin-pud = <EXYNOS_PIN_PULL_DOWN>;
> + };
> +
The above lines are not needed. There is already a sd0_rclk node with
exactly the same configuration just above your change.
> sd1_clk: sd1-clk {
> samsung,pins = "gpc1-0";
> samsung,pin-function = <EXYNOS_PIN_FUNC_2>;
> diff --git a/arch/arm/boot/dts/exynos5422-odroidxu3-common.dtsi
> b/arch/arm/boot/dts/exynos5422-odroidxu3-common.dtsi
> index b299e541cac0..d41397748ed2 100644
> --- a/arch/arm/boot/dts/exynos5422-odroidxu3-common.dtsi
> +++ b/arch/arm/boot/dts/exynos5422-odroidxu3-common.dtsi
> @@ -411,7 +411,7 @@
> samsung,dw-mshc-hs400-timing = <0 2>;
> samsung,read-strobe-delay = <90>;
> pinctrl-names = "default";
> - pinctrl-0 = <&sd0_clk &sd0_cmd &sd0_bus1 &sd0_bus4 &sd0_bus8 &sd0_cd
> &sd0_rclk>;
> + pinctrl-0 = <&sd0_clk &sd0_cmd &sd0_rdqs &sd0_bus1 &sd0_bus4 &sd0_bus8
> &sd0_cd &sd0_rclk>;
> bus-width = <8>;
> cap-mmc-highspeed;
> mmc-hs200-1_8v;
Best regards
--
Marek Szyprowski, PhD
Samsung R&D Institute Poland
