Hi Andrey,
On Mon, Mar 11, 2019 at 3:49 PM Andrey Smirnov <andrew.smir...@gmail.com> wrote:
> diff --git a/arch/arm/boot/dts/Makefile b/arch/arm/boot/dts/Makefile
> index f4f5aeaf3298..035ad9fc49f3 100644
> --- a/arch/arm/boot/dts/Makefile
> +++ b/arch/arm/boot/dts/Makefile
> @@ -607,7 +607,8 @@ dtb-$(CONFIG_SOC_VF610) += \
> vf610-zii-dev-rev-c.dtb \
> vf610-zii-scu4-aib.dtb \
> vf610-zii-ssmb-dtu.dtb \
> - vf610-zii-ssmb-spu3.dtb
> + vf610-zii-ssmb-spu3.dtb \
> + vf610-zii-spb4.dtb
Please keep it in alphabetical order.
> + gpio-leds {
> + compatible = "gpio-leds";
> + pinctrl-0 = <&pinctrl_leds_debug>;
> + pinctrl-names = "default";
> +
> + led-debug {
> + label = "zii:green:debug1";
> + gpios = <&gpio2 18 GPIO_ACTIVE_HIGH>;
> + linux,default-trigger = "heartbeat";
> + max-brightness = <1>;
This is an invalid property for gpio-leds. It is used for leds pwm
only. Please remove it.
> + };
> + };
> +
> + reg_vcc_3v3_mcu: regulator {
reg_vcc_3v3_mcu: regulator-vcc-3v3-mcu {
> +&dspi1 {
> + bus-num = <1>;
> + pinctrl-names = "default";
> + pinctrl-0 = <&pinctrl_dspi1>;
> + status = "okay";
> +
> + m25p128@0 {
Node names should be generic:
spi-nor@0
> +&i2c0 {
> + clock-frequency = <100000>;
> + pinctrl-names = "default";
> + pinctrl-0 = <&pinctrl_i2c0>;
> + status = "okay";
> +
> + gpio6: pca9505@22 {
io-expander@22
> + compatible = "nxp,pca9554";
> + reg = <0x22>;
> + gpio-controller;
> + #gpio-cells = <2>;
> + };
> +
> + at24c04@50 {
eeprom@50
> + compatible = "atmel,24c04";
> + reg = <0x50>;
> + label = "nameplate";
> + };
> +
> + at24c04@52 {
eeprom@52
