On Thu, 2019-03-07 at 15:14 +0100, Neil Armstrong wrote:
> Add the PCIe reference clock feeding the USB3 + PCIE combo PHY.
>
> This PLL needs a very precise register sequence to permit to be locked,
> thus using the specific clk-pll pcie ops.
>
> The PLL is then followed by :
> - a fixed /2 divider
> - a 5-bit 1-based divider
> - a final /2 divider
>
> This reference clock is fixed to 100MHz, thus only a single PLL setup
> is added.
>
> Signed-off-by: Neil Armstrong <narmstr...@baylibre.com>
> ---
> drivers/clk/meson/g12a.c | 118 +++++++++++++++++++++++++++++++++++++++
> drivers/clk/meson/g12a.h | 5 +-
> 2 files changed, 122 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/clk/meson/g12a.c b/drivers/clk/meson/g12a.c
> index 80a7172df2a6..d382c21a29e5 100644
> --- a/drivers/clk/meson/g12a.c
> +++ b/drivers/clk/meson/g12a.c
> @@ -614,6 +614,118 @@ static struct clk_regmap g12a_hifi_pll = {
> },
> };
>
> +/*
> + * The Meson G12A PCIE PLL is fined tuned to deliver a very precise
> + * 100MHz reference clock for the PCIe Analog PHY, and thus requires
> + * a strict register sequence to enable the PLL.
> + */
> +static const struct reg_sequence g12a_pcie_pll_init_regs[] = {
> + { .reg = HHI_PCIE_PLL_CNTL0, .def = 0x20090496 },
> + { .reg = HHI_PCIE_PLL_CNTL0, .def = 0x30090496 },
> + { .reg = HHI_PCIE_PLL_CNTL1, .def = 0x00000000 },
> + { .reg = HHI_PCIE_PLL_CNTL2, .def = 0x00001100 },
> + { .reg = HHI_PCIE_PLL_CNTL3, .def = 0x10058e00 },
> + { .reg = HHI_PCIE_PLL_CNTL4, .def = 0x000100c0 },
> + { .reg = HHI_PCIE_PLL_CNTL5, .def = 0x68000048 },
> + { .reg = HHI_PCIE_PLL_CNTL5, .def = 0x68000068, .delay_us = 20 },
> + { .reg = HHI_PCIE_PLL_CNTL4, .def = 0x008100c0, .delay_us = 10 },
> + { .reg = HHI_PCIE_PLL_CNTL0, .def = 0x34090496 },
> + { .reg = HHI_PCIE_PLL_CNTL0, .def = 0x14090496, .delay_us = 10 },
> + { .reg = HHI_PCIE_PLL_CNTL2, .def = 0x00001000 },
> +};
> +
> +/* Keep a single entry table for recalc/round_rate() ops */
> +static const struct pll_params_table g12a_pcie_pll_table[] = {
> + PLL_PARAMS(150, 1),
> + {0, 0},
> +};
> +
> +static struct clk_regmap g12a_pcie_pll_dco = {
> + .data = &(struct meson_clk_pll_data){
> + .en = {
> + .reg_off = HHI_PCIE_PLL_CNTL0,
> + .shift = 28,
> + .width = 1,
> + },
> + .m = {
> + .reg_off = HHI_PCIE_PLL_CNTL0,
> + .shift = 0,
> + .width = 8,
> + },
> + .n = {
> + .reg_off = HHI_PCIE_PLL_CNTL0,
> + .shift = 10,
> + .width = 5,
> + },
> + .frac = {
> + .reg_off = HHI_PCIE_PLL_CNTL1,
> + .shift = 0,
> + .width = 12,
> + },
> + .l = {
> + .reg_off = HHI_PCIE_PLL_CNTL0,
> + .shift = 31,
> + .width = 1,
> + },
> + .rst = {
> + .reg_off = HHI_PCIE_PLL_CNTL0,
> + .shift = 29,
> + .width = 1,
> + },
> + .table = g12a_pcie_pll_table,
> + .init_regs = g12a_pcie_pll_init_regs,
> + .init_count = ARRAY_SIZE(g12a_pcie_pll_init_regs),
> + },
> + .hw.init = &(struct clk_init_data){
> + .name = "pcie_pll_dco",
> + .ops = &meson_clk_pcie_pll_ops,
> + .parent_names = (const char *[]){ IN_PREFIX "xtal" },
> + .num_parents = 1,
> + },
> +};
> +
> +static struct clk_fixed_factor g12a_pcie_pll_dco_div2 = {
> + .mult = 1,
> + .div = 2,
> + .hw.init = &(struct clk_init_data){
> + .name = "pcie_pll_dco_div2",
> + .ops = &clk_fixed_factor_ops,
> + .parent_names = (const char *[]){ "pcie_pll_dco" },
> + .num_parents = 1,
> + .flags = CLK_SET_RATE_PARENT,
> + },
> +};
> +
> +static struct clk_regmap g12a_pcie_pll_od = {
> + .data = &(struct clk_regmap_div_data){
> + .offset = HHI_PCIE_PLL_CNTL0,
> + .shift = 16,
> + .width = 5,
> + .flags = CLK_DIVIDER_ROUND_CLOSEST |
> + CLK_DIVIDER_ONE_BASED |
> + CLK_DIVIDER_ALLOW_ZERO,
That's unusual !
Ods have always been power of two divider so far. I suppose you have noticed
and checked this as well ?
That being said, the doc seems to imply that the global post divider will
divide by 36, which seems difficult to reach with powers of two.
> + },
> + .hw.init = &(struct clk_init_data){
> + .name = "pcie_pll_od",
> + .ops = &clk_regmap_divider_ops,
> + .parent_names = (const char *[]){ "pcie_pll_dco_div2" },
> + .num_parents = 1,
> + .flags = CLK_SET_RATE_PARENT,
> + },
> +};
> +
> +static struct clk_fixed_factor g12a_pcie_pll = {
> + .mult = 1,
> + .div = 2,
> + .hw.init = &(struct clk_init_data){
> + .name = "pcie_pll_pll",
> + .ops = &clk_fixed_factor_ops,
> + .parent_names = (const char *[]){ "pcie_pll_od" },
> + .num_parents = 1,
> + .flags = CLK_SET_RATE_PARENT,
> + },
> +};
> +
> static struct clk_regmap g12a_hdmi_pll_dco = {
> .data = &(struct meson_clk_pll_data){
> .en = {
> @@ -2499,6 +2611,10 @@ static struct clk_hw_onecell_data g12a_hw_onecell_data
> = {
> [CLKID_CPU_CLK_AXI] = &g12a_cpu_clk_axi.hw,
> [CLKID_CPU_CLK_TRACE_DIV] = &g12a_cpu_clk_trace_div.hw,
> [CLKID_CPU_CLK_TRACE] = &g12a_cpu_clk_trace.hw,
> + [CLKID_PCIE_PLL_DCO] = &g12a_pcie_pll_dco.hw,
> + [CLKID_PCIE_PLL_DCO_DIV2] = &g12a_pcie_pll_dco_div2.hw,
> + [CLKID_PCIE_PLL_OD] = &g12a_pcie_pll_od.hw,
> + [CLKID_PCIE_PLL] = &g12a_pcie_pll.hw,
> [NR_CLKS] = NULL,
> },
> .num = NR_CLKS,
> @@ -2685,6 +2801,8 @@ static struct clk_regmap *const g12a_clk_regmaps[] = {
> &g12a_cpu_clk_axi,
> &g12a_cpu_clk_trace_div,
> &g12a_cpu_clk_trace,
> + &g12a_pcie_pll_od,
> + &g12a_pcie_pll_dco,
> };
>
> static const struct meson_eeclkc_data g12a_clkc_data = {
> diff --git a/drivers/clk/meson/g12a.h b/drivers/clk/meson/g12a.h
> index 70aa469ca1cf..1393a09730a6 100644
> --- a/drivers/clk/meson/g12a.h
> +++ b/drivers/clk/meson/g12a.h
> @@ -186,8 +186,11 @@
> #define CLKID_CPU_CLK_AXI 195
> #define CLKID_CPU_CLK_TRACE_DIV 196
> #define CLKID_CPU_CLK_TRACE 197
> +#define CLKID_PCIE_PLL_DCO 198
> +#define CLKID_PCIE_PLL_DCO_DIV2 199
> +#define CLKID_PCIE_PLL_OD 200
>
> -#define NR_CLKS 198
> +#define NR_CLKS 202
>
> /* include the CLKIDs that have been made part of the DT binding */
> #include <dt-bindings/clock/g12a-clkc.h>
