This series adds a devicetree for the i.MX507-based Kobo Aura e-book reader, and fixes a few things in imx50.dtsi along the way.
A lot of functionality is still missing: - poweroff/reboot, RTC, and battery monitoring support, as well as a PWM channel for the display backlight are provided by a custom embedded controller, which will be supported by a future patchset. The EC driver will also tell the EC to keep the board powered on; otherwise the EC will power the board off after about ten seconds (presumably to avoid battery drain if the OS is missing or corrupted) - The touchscreen controller, eKTF2132, currently doesn't have a mainline driver. - The e-paper display controller (EPDC) embedded in the i.MX50 SoC will need a whole new DRM driver, devicetree bindings, etc. - The TPS65185 PMIC, which generates the voltages necessary for driving the E Ink panel, also needs a driver - The backlight doesn't quite fit the existing pwm-backlight DT binding, because it uses an additional GPIO to boost the brightness. This requires some devicetree work - Linux doesn't currently support suspend-to-ram on i.MX50 In order to keep the system running when CONFIG_PM is enabled, the following fix is also required: https://lore.kernel.org/lkml/20190318231737.8459-1-j.neuschae...@gmx.net/ My own notes about this machine can be found here: https://github.com/neuschaefer/linux/wiki/Kobo-Aura Jonathan Neuschäfer (5): dt-bindings: Add vendor prefix for Rakuten Kobo, Inc. ARM: dts: imx50: Add Kobo Aura DTS ARM: dts: imx50: Add PHY node for usbotg and adjust clocks ARM: dts: imx50-kobo-aura: Enable USB support ARM: dts: imx50: Fix the numbering of the I2C controllers .../devicetree/bindings/vendor-prefixes.txt | 1 + arch/arm/boot/dts/Makefile | 3 +- arch/arm/boot/dts/imx50-kobo-aura.dts | 263 ++++++++++++++++++ arch/arm/boot/dts/imx50.dtsi | 14 +- 4 files changed, 279 insertions(+), 2 deletions(-) create mode 100644 arch/arm/boot/dts/imx50-kobo-aura.dts -- 2.20.1
