I have not yet tested later versions, but 2.4-test5 corrupts my jpegs. I
made an iso image and mounted it in loopback and they are corrupted; it
is not loopback doing it, I burned a CD and they were corrupted the same
way. I downgraded to 2.2.18 and that works fine.
If this is a known problem and/or has been addressed, great. If not, please
ping me and I'll try the latest 2.4 test and see if the problem has gone
away.
Config:
900Mhz K7 on ASUS A7V MB
PC100 mem w/ ECC (I don't think the board supports that; it's not enabled)
IDE devices:
/dev/hda is a Maxtor 91303D6, 12427MB w/512kB Cache, CHS=25249/16/63
/dev/hdb is a ATAPI 40X CD-ROM drive, 128kB Cache
/dev/hdc is a IBM-DTLA-307045, 43979MB w/1916kB Cache, CHS=5606/255/63
/dev/hdd is a IBM-DTLA-307045, 43979MB w/1916kB Cache, CHS=5606/255/63
SCSI devices:
/dev/sr0 is a MATSHITA CD-ROM, model CD-R CW-7502
4 ethernet interfaces
eth0: 3Com 3c905B Cyclone 100baseTx
eth1: 3Com 3c905B Cyclone 100baseTx
eth2: 3Com 3c905B Cyclone 100baseTx
eth3: 3Com 3c905 Boomerang 100baseTx
PCI bus devices:
Host bridge: VIA Technologies Unknown device (rev 2).
PCI bridge: VIA Technologies Unknown device (rev 0).
ISA bridge: VIA Technologies Unknown device (rev 34).
IDE interface: VIA Technologies VT 82C586 Apollo IDE (rev 16).
Host bridge: VIA Technologies Unknown device (rev 48).
Ethernet controller: 3Com 3C905B 100bTX (rev 48).
Ethernet controller: 3Com 3C905B 100bTX (rev 48).
Ethernet controller: 3Com 3C905B 100bTX (rev 48).
SCSI storage controller: Adaptec AIC-7850 (rev 3).
Ethernet controller: 3Com 3C905 100bTX (rev 0).
Unknown mass storage controller: Promise Technology Unknown device (rev 2).
VGA compatible controller: Matrox Matrox G200 AGP (rev 1).
--
---
Larry McVoy lm at bitmover.com http://www.bitmover.com/lm
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
Please read the FAQ at http://www.tux.org/lkml/
