Nits, probably Lorenzo will fix them up unless he sees more substantive things.
On Tue, Mar 26, 2019 at 12:00:55PM +0200, Jonathan Chocron wrote: > Adding support for Amazon's Annapurna Labs PCIe driver. Ideally, use "imperative mood", i.e., write it as a command: Add support for Amazon's Annapurna Labs PCIe driver. > The HW controller is based on DesignWare's IP. > > The HW doesn't support accessing the Root Port's config space via > ECAM, so we obtain its base address via an AMZN0001 device. > > Furthermore, the DesignWare PCIe controller doesn't filter out > config transactions sent to devices 1 and up on its bus, so they > are filtered by the driver. > All subordinate buses do support ECAM access. I didn't communicate my point very clearly. The above four lines should either be (1) a single paragraph, wrapped to fill the entire width, or (2) two paragraphs, with a blank line before "All subordinate buses ..." The fact that "... by the driver" ends in the middle of the line suggests that it's the end of the paragraph, but the fact that there's no blank line following suggests that it's not. So it creates an unnecessary hiccup for the reader. > Implementing specific PCI config access functions involves: > - Adding an init function to obtain the Root Port's base address > from an AMZN0001 device. > - Adding a new entry in the mcfg quirk array s/mcfg/MCFG/ since "MCFG" is an ACPI table ID, not a word. Bjorn