On 30/04/2019 11:12, Lokesh Vutla wrote:
> TI AM65x SoC based on K3 architecture introduced support for Events
> which are message based interrupts with minimal latency. These events
> are not compatible with regular interrupts and are valid only through
> an event transport lane. An Interrupt Aggregator(INTA) is introduced
> to convert these events to interrupts. INTA can also group 64 events
> into a single interrupt. Now the SoC has many peripherals and a large
> number of event sources (time sync or DMA), the use of events is
> completely dependent on a user's specific application, which drives a
> need for maximum flexibility in which event sources are used in the
> system. It is also completely up to software control as to how the
> events are serviced.
>
> Because of the huge flexibility there are certain standard peripherals
> (like GPIO etc)where all interrupts cannot be directly corrected to host
> interrupt controller. For this purpose, Interrupt Router(INTR) is
> introduced in the SoC. INTR just does a classic interrupt redirection.
>
> So the SoC has 3 types of interrupt controllers:
> - GIC500
> - Interrupt Router
> - Interrupt Aggregator
>
> Below is a diagrammatic view of how SoC integration of these interrupt
> controllers:(https://pastebin.ubuntu.com/p/9ngV3jdGj2/)
>
> Device Index-x Device Index-y
> | |
> | |
> ....
> \ /
> \ /
> \ (global events) /
> +---------------------------+ +---------+
> | | | |
> | INTA | | GPIO |
> | | | |
> +---------------------------+ +---------+
> | (vint) |
> | |
> \|/ |
> +---------------------------+ |
> | |<-------+
> | INTR |
> | |
> +---------------------------+
> |
> |
> \|/ (gic irq)
> +---------------------------+
> | |
> | GIC |
> | |
> +---------------------------+
>
> While at it, TISCI abstracts the handling of all above IRQ routes where
> interrupt sources are not directly connected to host interrupt controller.
> That would be configuration of Interrupt Aggregator and Interrupt Router.
>
> This series adds support for:
> - TISCI commands needed for IRQ configuration
> - Interrupt Router(INTR) driver.
> - Interrupt Aggregator(INTA) driver.
> - Interrupt Aggregator MSI bus layer.
>
> Marc,
> As discussed offline, the firmware changes are going to come within
> a day or so. These changes are tested against local binary which is
> bound to release.
>
> Boot Log: https://pastebin.ubuntu.com/p/YwprMKXdg4/
>
> Changes since v7:
> - Rebased on top of latest master.
> - Each patch has respective changes mentioned.
>
> Grygorii Strashko (1):
> firmware: ti_sci: Add support to get TISCI handle using of_phandle
>
> Lokesh Vutla (12):
> firmware: ti_sci: Add support for RM core ops
> firmware: ti_sci: Add support for IRQ management
> firmware: ti_sci: Add helper apis to manage resources
> genirq: Introduce irq_chip_{request,release}_resource_parent() apis
> gpio: thunderx: Use the default parent apis for
> {request,release}_resources
> dt-bindings: irqchip: Introduce TISCI Interrupt router bindings
> irqchip: ti-sci-intr: Add support for Interrupt Router driver
> dt-bindings: irqchip: Introduce TISCI Interrupt Aggregator bindings
> irqchip: ti-sci-inta: Add support for Interrupt Aggregator driver
> soc: ti: Add MSI domain bus support for Interrupt Aggregator
> irqchip: ti-sci-inta: Add msi domain support
> arm64: arch_k3: Enable interrupt controller drivers
>
> Peter Ujfalusi (1):
> firmware: ti_sci: Add RM mapping table for am654
>
> .../bindings/arm/keystone/ti,sci.txt | 3 +-
> .../interrupt-controller/ti,sci-inta.txt | 66 ++
> .../interrupt-controller/ti,sci-intr.txt | 82 +++
> MAINTAINERS | 6 +
> arch/arm64/Kconfig.platforms | 5 +
> drivers/firmware/ti_sci.c | 651 ++++++++++++++++++
> drivers/firmware/ti_sci.h | 102 +++
> drivers/gpio/gpio-thunderx.c | 16 +-
> drivers/irqchip/Kconfig | 23 +
> drivers/irqchip/Makefile | 2 +
> drivers/irqchip/irq-ti-sci-inta.c | 615 +++++++++++++++++
> drivers/irqchip/irq-ti-sci-intr.c | 275 ++++++++
> drivers/soc/ti/Kconfig | 6 +
> drivers/soc/ti/Makefile | 1 +
> drivers/soc/ti/ti_sci_inta_msi.c | 146 ++++
> include/linux/irq.h | 2 +
> include/linux/irqdomain.h | 1 +
> include/linux/msi.h | 10 +
> include/linux/soc/ti/ti_sci_inta_msi.h | 23 +
> include/linux/soc/ti/ti_sci_protocol.h | 124 ++++
> kernel/irq/chip.c | 27 +
> 21 files changed, 2173 insertions(+), 13 deletions(-)
> create mode 100644
> Documentation/devicetree/bindings/interrupt-controller/ti,sci-inta.txt
> create mode 100644
> Documentation/devicetree/bindings/interrupt-controller/ti,sci-intr.txt
> create mode 100644 drivers/irqchip/irq-ti-sci-inta.c
> create mode 100644 drivers/irqchip/irq-ti-sci-intr.c
> create mode 100644 drivers/soc/ti/ti_sci_inta_msi.c
> create mode 100644 include/linux/soc/ti/ti_sci_inta_msi.h
Lokesh,
Thanks for having respun this quickly.
I've applied the first 13 patches to irqchip-next (after tidying up some
of the commit messages). I've left the last patch for armsoc to take,
unless you guys insist on me taking it.
If nothing horrible appears in -next tomorrow, I'll send the 5.2 PR with
this series.
Hopefully we won't see more of this madness any time soon... :-/
Thanks,
M.
--
Jazz is not dead. It just smells funny...
