On Wed, Jun 12, 2019 at 09:31:15PM +0200, Martin Blumenstingl wrote:
> Switch stmmac_mdio_reset to use GPIO descriptors. GPIO core handles the
> "snps,reset-gpio" for GPIO descriptors so we don't need to take care of
> it inside the driver anymore.
>
> The advantage of this is that we now preserve the GPIO flags which are
> passed via devicetree. This is required on some newer Amlogic boards
> which use an Open Drain pin for the reset GPIO. This pin can only output
> a LOW signal or switch to input mode but it cannot output a HIGH signal.
> There are already devicetree bindings for these special cases and GPIO
> core already takes care of them but only if we use GPIO descriptors
> instead of GPIO numbers.
>
> Signed-off-by: Martin Blumenstingl <martin.blumensti...@googlemail.com>
> Reviewed-by: Linus Walleij <linus.wall...@linaro.org>
Reviewed-by: Andrew Lunn <and...@lunn.ch>
Andrew
