Hello! On 06/20/2019 08:22 PM, Vignesh Raghavendra wrote:
> Cypress' HyperBus is Low Signal Count, High Performance Double Data Rate > Bus interface between a host system master and one or more slave > interfaces. HyperBus is used to connect microprocessor, microcontroller, > or ASIC devices with random access NOR flash memory (called HyperFlash) > or self refresh DRAM (called HyperRAM). > > Its a 8-bit data bus (DQ[7:0]) with Read-Write Data Strobe (RWDS) > signal and either Single-ended clock(3.0V parts) or Differential clock > (1.8V parts). It uses ChipSelect lines to select b/w multiple slaves. > At bus level, it follows a separate protocol described in HyperBus > specification[1]. > > HyperFlash follows CFI AMD/Fujitsu Extended Command Set (0x0002) similar > to that of existing parallel NORs. Since HyperBus is x8 DDR bus, > its equivalent to x16 parallel NOR flash wrt bits per clock cycle. But > HyperBus operates at >166MHz frequencies. s/wrt/WRT/. > HyperRAM provides direct random read/write access to flash memory > array. > > But, HyperBus memory controllers seem to abstract implementation details > and expose a simple MMIO interface to access connected flash. > > Add support for registering HyperFlash devices with MTD framework. MTD > maps framework along with CFI chip support framework are used to support > communicating with flash. > > Framework is modelled along the lines of spi-nor framework. HyperBus > memory controller (HBMC) drivers calls hyperbus_register_device() to > register a single HyperFlash device. HyperFlash core parses MMIO access > information from DT, sets up the map_info struct, probes CFI flash and > registers it with MTD framework. > > Some HBMC masters need calibration/training sequence[3] to be carried > out, in order for DLL inside the controller to lock, by reading a known > string/pattern. This is done by repeatedly reading CFI Query > Identification String. Calibration needs to be done before trying to detect > flash as part of CFI flash probe. > > HyperRAM is not supported at the moment. > > HyperBus specification can be found at[1] > HyperFlash datasheet can be found at[2] > > [1] https://www.cypress.com/file/213356/download > [2] https://www.cypress.com/file/213346/download > [3] http://www.ti.com/lit/ug/spruid7b/spruid7b.pdf > Table 12-5741. HyperFlash Access Sequence > > Signed-off-by: Vignesh Raghavendra <vigne...@ti.com> [...] > diff --git a/include/linux/mtd/hyperbus.h b/include/linux/mtd/hyperbus.h > new file mode 100644 > index 000000000000..ead969aad35b > --- /dev/null > +++ b/include/linux/mtd/hyperbus.h > @@ -0,0 +1,86 @@ [...] > +/** > + * struct hyperbus_ops - struct representing custom HyperBus operations > + * @read16: read 16 bit of data to flash in a single burst. Used to read s/to flash/from flash/. [...] > +#endif /* __LINUX_MTD_HYPERBUS_H__ */ I thought you agreed to add the #defines for the HF commands. Well, I can add them as well... MBR, Sergei