On 24/06/2019 19.26, Willem de Bruijn wrote: > On Mon, Jun 24, 2019 at 4:34 AM Rasmus Villemoes > <[email protected]> wrote: >> >> CONFIG_CAN_LEDS is deprecated. When trying to use the generic netdev >> trigger as suggested, there's a small inconsistency with the link >> property: The LED is on initially, stays on when the device is brought >> up, and then turns off (as expected) when the device is brought down. >> >> Make sure the LED always reflects the state of the CAN device. >> >> Signed-off-by: Rasmus Villemoes <[email protected]> > > Should this target net?
No, I think this should go through the CAN tree. Perhaps I've misunderstood when to use the net-next prefix - is that only for things that should be applied directly to the net-next tree? If so, sorry. > Regardless of CONFIG_CAN_LEDS deprecation, > this is already not initialized properly if that CONFIG is disabled > and a can_led_event call at device probe is a noop. I'm not sure I understand this part. The CONFIG_CAN_LEDS support for showing the state of the interface is implemented via hooking into the ndo_open/ndo_stop callbacks, and does not look at or touch the __LINK_STATE_NOCARRIER bit at all. Other than via the netdev LED trigger I don't think one can even observe the slightly odd initial state of the __LINK_STATE_NOCARRIER bit for CAN devices, which is why I framed this as a fix purely to allow the netdev trigger to be a closer drop-in replacement for CONFIG_CAN_LEDS. Rasmus
