From: Yunsheng Lin <linyunsh...@huawei.com>
When hdev->tx_sch_mode is HCLGE_FLAG_VNET_BASE_SCH_MODE, the
hclge_tm_schd_mode_vnet_base_cfg calls hclge_tm_pri_schd_mode_cfg
with vport->vport_id as pri_id, which is used as index for
hdev->tm_info.tc_info, it will cause out of bound access issue
if vport_id is equal to or larger than HNAE3_MAX_TC.
Also hardware only support maximum speed of HCLGE_ETHER_MAX_RATE.
So this patch adds two checks for above cases.
Fixes: 848440544b41 ("net: hns3: Add support of TX Scheduler & Shaper to HNS3
driver")
Signed-off-by: Yunsheng Lin <linyunsh...@huawei.com>
Signed-off-by: Peng Li <lipeng...@huawei.com>
Signed-off-by: Huazhong Tan <tanhuazh...@huawei.com>
---
drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_tm.c | 6 +++++-
1 file changed, 5 insertions(+), 1 deletion(-)
diff --git a/drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_tm.c
b/drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_tm.c
index cb2fb5a..3f41fa2 100644
--- a/drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_tm.c
+++ b/drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_tm.c
@@ -58,7 +58,8 @@ static int hclge_shaper_para_calc(u32 ir, u8 shaper_level,
u32 tick;
/* Calc tick */
- if (shaper_level >= HCLGE_SHAPER_LVL_CNT)
+ if (shaper_level >= HCLGE_SHAPER_LVL_CNT ||
+ ir > HCLGE_ETHER_MAX_RATE)
return -EINVAL;
tick = tick_array[shaper_level];
@@ -1138,6 +1139,9 @@ static int hclge_tm_schd_mode_vnet_base_cfg(struct
hclge_vport *vport)
int ret;
u8 i;
+ if (vport->vport_id >= HNAE3_MAX_TC)
+ return -EINVAL;
+
ret = hclge_tm_pri_schd_mode_cfg(hdev, vport->vport_id);
if (ret)
return ret;
--
2.7.4
