Add devicetree binding for IMX290 CMOS image sensor.

Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasi...@linaro.org>
---
 .../devicetree/bindings/media/i2c/imx290.txt  | 51 +++++++++++++++++++
 1 file changed, 51 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/media/i2c/imx290.txt

diff --git a/Documentation/devicetree/bindings/media/i2c/imx290.txt 
b/Documentation/devicetree/bindings/media/i2c/imx290.txt
new file mode 100644
index 000000000000..7535b5b5b24b
--- /dev/null
+++ b/Documentation/devicetree/bindings/media/i2c/imx290.txt
@@ -0,0 +1,51 @@
+* Sony IMX290 1/2.8-Inch CMOS Image Sensor
+
+The Sony IMX290 is a 1/2.8-Inch CMOS Solid-state image sensor with
+Square Pixel for Color Cameras. It is programmable through I2C and 4-wire
+interfaces. The sensor output is available via CMOS logic parallel SDR output,
+Low voltage LVDS DDR output and CSI-2 serial data output.
+
+Required Properties:
+- compatible: Should be "sony,imx290"
+- reg: I2C bus address of the device
+- clocks: Reference to the xclk clock.
+- clock-names: Should be "xclk".
+- clock-frequency: Frequency of the xclk clock.
+- vdddo-supply: Sensor digital IO regulator.
+- vdda-supply: Sensor analog regulator.
+- vddd-supply: Sensor digital core regulator.
+
+Optional Properties:
+- reset-gpios: Sensor reset GPIO
+
+The imx290 device node should contain one 'port' child node with
+an 'endpoint' subnode. For further reading on port node refer to
+Documentation/devicetree/bindings/media/video-interfaces.txt.
+
+Example:
+       &i2c1 {
+               ...
+               imx290: imx290@1a {
+                       compatible = "sony,imx290";
+                       reg = <0x1a>;
+
+                       reset-gpios = <&msmgpio 35 GPIO_ACTIVE_LOW>;
+                       pinctrl-names = "default";
+                       pinctrl-0 = <&camera_rear_default>;
+
+                       clocks = <&gcc GCC_CAMSS_MCLK0_CLK>;
+                       clock-names = "xclk";
+                       clock-frequency = <37125000>;
+
+                       vdddo-supply = <&camera_vdddo_1v8>;
+                       vdda-supply = <&camera_vdda_2v8>;
+                       vddd-supply = <&camera_vddd_1v5>;
+
+                       port {
+                               imx290_ep: endpoint {
+                                       clock-lanes = <1>;
+                                       data-lanes = <0 2 3 4>;
+                                       remote-endpoint = <&csiphy0_ep>;
+                               };
+                       };
+               };
-- 
2.17.1

Reply via email to