On Fri, Jul 05, 2019 at 11:57:14AM +0100, Pawel Laszczak wrote: > Patch moves some decoding functions from driver/usb/dwc3/debug.h driver > to driver/usb/gadget/debug.c file. These moved functions include: > dwc3_decode_get_status > dwc3_decode_set_clear_feature > dwc3_decode_set_address > dwc3_decode_get_set_descriptor > dwc3_decode_get_configuration > dwc3_decode_set_configuration > dwc3_decode_get_intf > dwc3_decode_set_intf > dwc3_decode_synch_frame > dwc3_decode_set_sel > dwc3_decode_set_isoch_delay > dwc3_decode_ctrl > > These functions are used also in inroduced cdns3 driver. > > All functions prefixes were changed from dwc3 to usb. > Also, function's parameters has been extended according to the name > of fields in standard SETUP packet. > Additionally, patch adds usb_decode_ctrl function to > include/linux/usb/gadget.h file.
No it does not :( > Signed-off-by: Pawel Laszczak <paw...@cadence.com> > --- > drivers/usb/common/Makefile | 5 + > drivers/usb/common/debug.c | 268 ++++++++++++++++++++++++++++++++++++ > drivers/usb/dwc3/debug.h | 252 --------------------------------- > drivers/usb/dwc3/trace.h | 2 +- > include/linux/usb/ch9.h | 25 ++++ > 5 files changed, 299 insertions(+), 253 deletions(-) > create mode 100644 drivers/usb/common/debug.c > > diff --git a/drivers/usb/common/Makefile b/drivers/usb/common/Makefile > index 0a7c45e85481..cdc66b59a6f0 100644 > --- a/drivers/usb/common/Makefile > +++ b/drivers/usb/common/Makefile > @@ -5,6 +5,11 @@ > > obj-$(CONFIG_USB_COMMON) += usb-common.o > usb-common-y += common.o > + > +ifneq ($(CONFIG_TRACING),) > + usb-common-y += debug.o > +endif So only enable this if tracing is not emabled? Or if enabled? I'm confused, isn't there an easier way to write this? thanks, greg k-h
