Thanks for checking my patch.
> On Thu, May 30, 2019 at 06:22:11PM +0900, Takao Orito wrote:
> > Add the device-tree binding documentation for Milbeaut SDHCI driver.
> >
> > Signed-off-by: Takao Orito <orito.ta...@socionext.com>
> > ---
> > .../devicetree/bindings/mmc/sdhci-milbeaut.txt | 32
> > ++++++++++++++++++++++
> > 1 file changed, 32 insertions(+)
> > create mode 100644 Documentation/devicetree/bindings/mmc/sdhci-milbeaut.txt
> >
> > diff --git a/Documentation/devicetree/bindings/mmc/sdhci-milbeaut.txt
> > b/Documentation/devicetree/bindings/mmc/sdhci-milbeaut.txt
> > new file mode 100644
> > index 0000000..6063116
> > --- /dev/null
> > +++ b/Documentation/devicetree/bindings/mmc/sdhci-milbeaut.txt
> > @@ -0,0 +1,32 @@
> > +* SOCIONEXT Milbeaut SDHCI controller
> > +
> > +This file documents differences between the core properties in mmc.txt
> > +and the properties used by the sdhci_milbeaut driver.
> > +
> > +Required properties:
> > +- compatible: "socionext,milbeaut-m10v-sdhci-3.0"
> > +- clocks: Must contain an entry for each entry in clock-names. It is a
> > + list of phandles and clock-specifier pairs.
> > + See ../clocks/clock-bindings.txt for details.
> > +- clock-names: Should contain the following two entries:
> > + "iface" - clock used for sdhci interface
> > + "core" - core clock for sdhci controller
> > +- vmmc-supply: a phandle of a fixed GPIO regulator
>
> Being a fixed GPIO regulator is board specific and outside the scope of
> the binding. Otherwise,
>
> Reviewed-by: Rob Herring <r...@kernel.org>
I see. I will remove vmmc-supply and send new patch.
Thanks
Orito
>
> > +
> > +Optional properties:
> > +- fujitsu,cmd-dat-delay-select: boolean property indicating that this host
> > + requires the CMD_DAT_DELAY control to be enabled.
> > +
> > +Example:
> > + sdhci3: mmc@1b010000 {
> > + compatible = "socionext,milbeaut-m10v-sdhci-3.0";
> > + reg = <0x1b010000 0x10000>;
> > + interrupts = <0 265 0x4>;
> > + voltage-ranges = <3300 3300>;
> > + bus-width = <4>;
> > + clocks = <&clk 7>, <&ahb_clk>;
> > + clock-names = "core", "iface";
> > + cap-sdio-irq;
> > + vmmc-supply = <&vcc_sdhci3>;
> > + fujitsu,cmd-dat-delay-select;
> > + };
> > --
> > 1.9.1
> >
> >
--
Takao Orito <orito.ta...@socionext.com>
