This adds device tree bindings of the poweroff driver
for power managing micro controller units that are connected
to a board via the UART interface.
Signed-off-by: Evgeny Kolesnikov <evge...@gmail.com>
---
.../bindings/power/reset/uart-poweroff.txt | 38 +++++++++++++++++++
1 file changed, 38 insertions(+)
create mode 100644
Documentation/devicetree/bindings/power/reset/uart-poweroff.txt
diff --git a/Documentation/devicetree/bindings/power/reset/uart-poweroff.txt
b/Documentation/devicetree/bindings/power/reset/uart-poweroff.txt
new file mode 100644
index 000000000000..86d036271b51
--- /dev/null
+++ b/Documentation/devicetree/bindings/power/reset/uart-poweroff.txt
@@ -0,0 +1,38 @@
+* UART-based PM MCU power off driver
+
+Some devices have a microcontroller controlling the main power
+supply. This microcontroller is connected to UART of the SoC.
+Sending a sequence of characters tells the MCU to turn
+the power off.
+
+The length of the sequence, baud rate and the timeout to process
+the command may vary from device to device.
+
+This driver could be used for WD My Cloud (Marvell SoCs), QNAP
+(Kirkwood and Orion5x SoCs) and Synology NAS devices.
+
+Required properties:
+- compatible: Should be "uart-poweroff"
+- reg: Address and length of the register set for UART
+- clocks: The tclk clock
+- cmd: Array of bytes, the command to send to the MCU
+- baud: Baud rate [75..460800]
+
+Optional properties:
+- byte-delay: A delay after each byte of a command, could be useful
+ for sloppy MCUs [ms], default value is 5
+- timeout: A timeout to wait for the MCU to process the command [ms],
+ default value is 1000
+- override: Boolean flag that indicates if the driver should
+ prioritize itself over any existing power off driver,
+ default behaviour is not to interfere
+
+Example:
+ poweroff@12100 {
+ compatible = "uart-poweroff";
+ reg = <0x12100 0x100>;
+ clocks = <&coreclk 0>;
+ baud = <19200>;
+ cmd = [fa 03 03 01 00 00 fb];
+ status = "okay";
+ };
--
2.21.0
