[ Upstream commit e1d9149e8389f1690cdd4e4056766dd26488a0fe ]
Before this patch, the Type-C port on the Sapphire board is dead.
If setting the 'regulator-always-on' property to 'vcc5v0_typec0'
then the port works for about 4 seconds at start-up. This is a
sample trace with a memory stick plugged in:
1.- The memory stick LED lights on and kernel reports:
[ 4.782999] scsi 0:0:0:0: Direct-Access USB DISK PMAP PQ: 0 ANSI: 4
[ 5.904580] sd 0:0:0:0: [sdb] 3913344 512-byte logical blocks: (2.00 GB/1.87
GiB)
[ 5.906860] sd 0:0:0:0: [sdb] Write Protect is off
[ 5.908973] sd 0:0:0:0: [sdb] Mode Sense: 23 00 00 00
[ 5.909122] sd 0:0:0:0: [sdb] No Caching mode page found
[ 5.911214] sd 0:0:0:0: [sdb] Assuming drive cache: write through
[ 5.951585] sdb: sdb1
[ 5.954816] sd 0:0:0:0: [sdb] Attached SCSI removable disk
2.- 4 seconds later the memory stick LED lights off and kernel reports:
[ 9.082822] phy phy-ff770000.syscon:usb2-phy@e450.2: charger =
USB_DCP_CHARGER
3.- After a minute the kernel reports:
[ 71.666761] usb 5-1: USB disconnect, device number 2
It has been checked that, although the LED is off, VBUS is present.
If, instead, the dr_mode is changed to host and the phy-supply changed
accordingly, then it works. It has only been tested in host mode.
Signed-off-by: Vicente Bergas <vice...@gmail.com>
Signed-off-by: Heiko Stuebner <he...@sntech.de>
Signed-off-by: Sasha Levin <sas...@kernel.org>
---
arch/arm64/boot/dts/rockchip/rk3399-sapphire.dtsi | 5 ++---
1 file changed, 2 insertions(+), 3 deletions(-)
diff --git a/arch/arm64/boot/dts/rockchip/rk3399-sapphire.dtsi
b/arch/arm64/boot/dts/rockchip/rk3399-sapphire.dtsi
index 04623e52ac5db..1bc1579674e57 100644
--- a/arch/arm64/boot/dts/rockchip/rk3399-sapphire.dtsi
+++ b/arch/arm64/boot/dts/rockchip/rk3399-sapphire.dtsi
@@ -565,12 +565,11 @@
status = "okay";
u2phy0_otg: otg-port {
- phy-supply = <&vcc5v0_typec0>;
status = "okay";
};
u2phy0_host: host-port {
- phy-supply = <&vcc5v0_host>;
+ phy-supply = <&vcc5v0_typec0>;
status = "okay";
};
};
@@ -620,7 +619,7 @@
&usbdrd_dwc3_0 {
status = "okay";
- dr_mode = "otg";
+ dr_mode = "host";
};
&usbdrd3_1 {
--
2.20.1
