On 28.07.2019 18:20, Daniel Baluta wrote:
> From: Abel Vesa <abel.v...@nxp.com>
>
> Add the initial configuration for clocks that need default parent and rate
> setting. This is based on the vendor tree clock provider parents and rates
> configuration except this is doing the setup in dts rather then using clock
> consumer API in a clock provider driver.
>
> Note that by adding the initial rate setting for audio_pll1/audio_pll
> setting we need to remove it from imx8mq-librem5-devkit.dts
Setting default rates for audio_pll1 and audio_pll2 in soc dtsi makes a
lot of sense to me; the intention is for one to run at a multiple of
44.1k and another at a multiple of 48k.
> diff --git a/arch/arm64/boot/dts/freescale/imx8mq.dtsi
> b/arch/arm64/boot/dts/freescale/imx8mq.dtsi
> index 02fbd0625318..a55d72ba2e05 100644
> --- a/arch/arm64/boot/dts/freescale/imx8mq.dtsi
> +++ b/arch/arm64/boot/dts/freescale/imx8mq.dtsi
> @@ -494,6 +494,25 @@
> clock-names = "ckil", "osc_25m", "osc_27m",
> "clk_ext1", "clk_ext2",
> "clk_ext3", "clk_ext4";
> + assigned-clocks = <&clk IMX8MQ_VIDEO_PLL1>,
> + <&clk IMX8MQ_AUDIO_PLL1>,
> + <&clk IMX8MQ_AUDIO_PLL2>,
> + <&clk IMX8MQ_CLK_AHB>,
> + <&clk IMX8MQ_CLK_NAND_USDHC_BUS>,
> + <&clk IMX8MQ_CLK_AUDIO_AHB>,
> + <&clk IMX8MQ_VIDEO_PLL1_REF_SEL>,
> + <&clk IMX8MQ_CLK_NOC>;
> + assigned-clock-parents = <0>,
> + <0>,
> + <0> > +
> <&clk IMX8MQ_SYS1_PLL_133M>,
> + <&clk IMX8MQ_SYS1_PLL_266M>,
> + <&clk IMX8MQ_SYS2_PLL_500M>,
> + <&clk IMX8MQ_CLK_27M>,
> + <&clk IMX8MQ_SYS1_PLL_800M>;
> + assigned-clock-rates = <593999999>,
> + <786432000>,
> + <722534400>;
The audio PLLs should run below 650 mHz so please use 393216000 and
361267200 instead of 786432000 and 722534400. For the 8mm equivalent see
commit 053a4ffe2988 ("clk: imx: imx8mm: fix audio pll setting").
You should also move the unbypassing of AUDIO_PLL1 and AUDIO_PLL2 here
just add two more assigned-clocks and assigned-clock-parents.
--
Regards,
Leonard
