When an error occurs, existing logging uses dbg() so the cause of a
problem is hard to determine. Error conditions shouldn't only be
properly reported with debugging enabled.
A side effect of this change is that when an uninitialised device
is started, a log message similar to the following is sent:
cxacru 5-2:1.0: receive of cm 0x90 failed (-104)
This is normal - the device did not respond so firmware will be
loaded.
Signed-Off-By: Simon Arlott <[EMAIL PROTECTED]>
---
On 23/09/07 17:17, Duncan Sands wrote:
> Hi Simon, don't these error messages (except the first) risk spamming
> the log if something goes wrong (like the modem being unplugged)? How
> about rate-limiting them, like usbatm does?
>
> Ciao,
>
> Duncan.
Ok.
drivers/usb/atm/cxacru.c | 43 ++++++++++++++++++++++++++++---------------
1 files changed, 28 insertions(+), 15 deletions(-)
diff --git a/drivers/usb/atm/cxacru.c b/drivers/usb/atm/cxacru.c
index 1e5ee88..50249a5 100644
--- a/drivers/usb/atm/cxacru.c
+++ b/drivers/usb/atm/cxacru.c
@@ -482,7 +482,9 @@ static int cxacru_cm(struct cxacru_data *instance, enum
cxacru_cm_request cm,
int rbuflen = ((rsize - 1) / stride + 1) * CMD_PACKET_SIZE;
if (wbuflen > PAGE_SIZE || rbuflen > PAGE_SIZE) {
- dbg("too big transfer requested");
+ if (printk_ratelimit())
+ usb_err(instance->usbatm, "requested transfer size too
large (%d, %d)\n",
+ wbuflen, rbuflen);
ret = -ENOMEM;
goto fail;
}
@@ -493,8 +495,9 @@ static int cxacru_cm(struct cxacru_data *instance, enum
cxacru_cm_request cm,
init_completion(&instance->rcv_done);
ret = usb_submit_urb(instance->rcv_urb, GFP_KERNEL);
if (ret < 0) {
- dbg("submitting read urb for cm %#x failed", cm);
- ret = ret;
+ if (printk_ratelimit())
+ usb_err(instance->usbatm, "submit of read urb for cm
%#x failed (%d)\n",
+ cm, ret);
goto fail;
}
@@ -510,27 +513,29 @@ static int cxacru_cm(struct cxacru_data *instance, enum
cxacru_cm_request cm,
init_completion(&instance->snd_done);
ret = usb_submit_urb(instance->snd_urb, GFP_KERNEL);
if (ret < 0) {
- dbg("submitting write urb for cm %#x failed", cm);
- ret = ret;
+ if (printk_ratelimit())
+ usb_err(instance->usbatm, "submit of write urb for cm
%#x failed (%d)\n",
+ cm, ret);
goto fail;
}
ret = cxacru_start_wait_urb(instance->snd_urb, &instance->snd_done,
NULL);
if (ret < 0) {
- dbg("sending cm %#x failed", cm);
- ret = ret;
+ if (printk_ratelimit())
+ usb_err(instance->usbatm, "send of cm %#x failed
(%d)\n", cm, ret);
goto fail;
}
ret = cxacru_start_wait_urb(instance->rcv_urb, &instance->rcv_done,
&actlen);
if (ret < 0) {
- dbg("receiving cm %#x failed", cm);
- ret = ret;
+ if (printk_ratelimit())
+ usb_err(instance->usbatm, "receive of cm %#x failed
(%d)\n", cm, ret);
goto fail;
}
if (actlen % CMD_PACKET_SIZE || !actlen) {
- dbg("response is not a positive multiple of %d: %#x",
- CMD_PACKET_SIZE, actlen);
+ if (printk_ratelimit())
+ usb_err(instance->usbatm, "invalid response length to
cm %#x: %d\n",
+ cm, actlen);
ret = -EIO;
goto fail;
}
@@ -538,12 +543,16 @@ static int cxacru_cm(struct cxacru_data *instance, enum
cxacru_cm_request cm,
/* check the return status and copy the data to the output buffer, if
needed */
for (offb = offd = 0; offd < rsize && offb < actlen; offb +=
CMD_PACKET_SIZE) {
if (rbuf[offb] != cm) {
- dbg("wrong cm %#x in response", rbuf[offb]);
+ if (printk_ratelimit())
+ usb_err(instance->usbatm, "wrong cm %#x in
response to cm %#x\n",
+ rbuf[offb], cm);
ret = -EIO;
goto fail;
}
if (rbuf[offb + 1] != CM_STATUS_SUCCESS) {
- dbg("response failed: %#x", rbuf[offb + 1]);
+ if (printk_ratelimit())
+ usb_err(instance->usbatm, "response to cm %#x
failed: %#x\n",
+ cm, rbuf[offb + 1]);
ret = -EIO;
goto fail;
}
@@ -582,14 +591,18 @@ static int cxacru_cm_get_array(struct cxacru_data
*instance, enum cxacru_cm_requ
for (offb = 0; offb < len; ) {
int l = le32_to_cpu(buf[offb++]);
if (l > stride || l > (len - offb) / 2) {
- dbg("wrong data length %#x in response", l);
+ if (printk_ratelimit())
+ usb_err(instance->usbatm, "invalid data length
from cm %#x: %d\n",
+ cm, l);
ret = -EIO;
goto cleanup;
}
while (l--) {
offd = le32_to_cpu(buf[offb++]);
if (offd >= size) {
- dbg("wrong index %#x in response", offd);
+ if (printk_ratelimit())
+ usb_err(instance->usbatm, "wrong index
#%x in response to cm #%x\n",
+ offd, cm);
ret = -EIO;
goto cleanup;
}
--
1.5.0.1
--
Simon Arlott
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
