On Sun, May 3, 2020 at 7:22 PM Jonathan Bakker <[email protected]> wrote:
> The bma180 IIO driver has been extended for support for bma023. > However, this could cause conflicts with this driver. Since some > setups may depend upon the evdev setup, disable support in this > driver for the bma023 only when the IIO driver is being built. > > Signed-off-by: Jonathan Bakker <[email protected]> I would just fix this with KConfig instead, like add mutually exclusive depends on these two drivers. Set this input driver as: depends on BMA180=n And the IIO driver as: depends on INPUT_BMA150=n It's a rough measure but this input driver should anyway go away. Yours, Linus Walleij
