Hi Richard,
On Tue, May 12, 2020 at 08:27:31AM -0500, [email protected] wrote:
> From: Richard Gong <[email protected]>
>
> The reconfiguration mode is pre-set by driver as the full reconfiguration.
> As a result, user have to change code and recompile the drivers if he or
> she wants to perform a partial reconfiguration. Removing the pre-set
> reconfiguration condition so that user can select full or partial
> reconfiguration via overlay device tree without recompiling the drivers.
>
> Also add an error message if the configuration request is failure.
>
> Signed-off-by: Richard Gong <[email protected]>
> ---
> drivers/fpga/stratix10-soc.c | 5 +++--
> 1 file changed, 3 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/fpga/stratix10-soc.c b/drivers/fpga/stratix10-soc.c
> index 44b7c56..2da8a40 100644
> --- a/drivers/fpga/stratix10-soc.c
> +++ b/drivers/fpga/stratix10-soc.c
> @@ -182,12 +182,12 @@ static int s10_ops_write_init(struct fpga_manager *mgr,
> uint i;
> int ret;
>
> - ctype.flags = 0;
> if (info->flags & FPGA_MGR_PARTIAL_RECONFIG) {
> dev_dbg(dev, "Requesting partial reconfiguration.\n");
> - ctype.flags |= BIT(COMMAND_RECONFIG_FLAG_PARTIAL);
> + ctype.flags = 1;
Have you considered:
ctype.flags = BIT(COMMAND_RECONFIG_FLAG_PARTIAL);
instead (assuming 1, lines up with BIT(COMMAND_RECONFIG_FLAG_PARTIAL)?
If not: Can you define a constant?
> } else {
> dev_dbg(dev, "Requesting full reconfiguration.\n");
> + ctype.flags = 0;
> }
>
> reinit_completion(&priv->status_return_completion);
> @@ -210,6 +210,7 @@ static int s10_ops_write_init(struct fpga_manager *mgr,
>
> ret = 0;
> if (!test_and_clear_bit(SVC_STATUS_OK, &priv->status)) {
> + dev_err(dev, "RECONFIG_REQUEST failed\n");
> ret = -ETIMEDOUT;
> goto init_done;
> }
> --
> 2.7.4
>
Cheers,
Moritz
