On 5/14/2020 2:29 AM, Mathieu Poirier wrote:
Hi Arun,
On Wed, May 13, 2020 at 10:40:02AM +0530, Arun Kumar Neelakantam wrote:
From: Chris Lew <c...@codeaurora.org>
The open_req and open_ack completion variables are the state variables
to represet a remote channel as open. Use complete_all so there are no
s/represet/represent
done added in patch set 6
races with waiters and using completion_done.
Signed-off-by: Chris Lew <c...@codeaurora.org>
Signed-off-by: Arun Kumar Neelakantam <ane...@codeaurora.org>
---
drivers/rpmsg/qcom_glink_native.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/rpmsg/qcom_glink_native.c
b/drivers/rpmsg/qcom_glink_native.c
index 1995f5b..604f11f 100644
--- a/drivers/rpmsg/qcom_glink_native.c
+++ b/drivers/rpmsg/qcom_glink_native.c
@@ -970,7 +970,7 @@ static int qcom_glink_rx_open_ack(struct qcom_glink *glink,
unsigned int lcid)
return -EINVAL;
}
- complete(&channel->open_ack);
+ complete_all(&channel->open_ack);
If you do this and as per the note in the comment section above
completion_done(), there shouldn't be a need to call completion_done() in
qcom_glink_announce_create().
Thanks,
Mathieu
the completion_done() check still required to avoid sending intent
request on channel which only opened by remote.
return 0;
}
@@ -1413,7 +1413,7 @@ static int qcom_glink_rx_open(struct qcom_glink *glink,
unsigned int rcid,
channel->rcid = ret;
spin_unlock_irqrestore(&glink->idr_lock, flags);
- complete(&channel->open_req);
+ complete_all(&channel->open_req);
if (create_device) {
rpdev = kzalloc(sizeof(*rpdev), GFP_KERNEL);
--
2.7.4
