On Thu, May 21, 2020 at 02:09:10PM +0300, Tali Perry wrote:
> Add support for slave mode for Nuvoton
> NPCM BMC I2C controller driver.
...
> +#if IS_ENABLED(CONFIG_I2C_SLAVE)
> +/*
> + * npcm_i2caddr array:
> + * The module supports having multiple own slave addresses.
> + * Since the addr regs are sprinkled all over the address space,
> + * use this array to get the address or each register.
> + */
> +#define I2C_NUM_OWN_ADDR 10
> +const int npcm_i2caddr[I2C_NUM_OWN_ADDR] = {NPCM_I2CADDR1, NPCM_I2CADDR2,
Extra spaces.
On top. please start assignment from the new line.
> + NPCM_I2CADDR3, NPCM_I2CADDR4,
> + NPCM_I2CADDR5, NPCM_I2CADDR6,
> + NPCM_I2CADDR7, NPCM_I2CADDR8,
> + NPCM_I2CADDR9, NPCM_I2CADDR10};
Split }; to new line and leave comma with the last member.
> +#endif
...
> +static int npcm_i2c_slave_enable(struct npcm_i2c *bus, enum i2c_addr
> addr_type,
> + u8 addr, bool enable)
Extra spaces. Check entire patch for that and fix accordingly.
> +#if IS_ENABLED(CONFIG_I2C_SLAVE)
> + if (bus->slave)
> + npcm_i2c_slave_enable(bus, I2C_SLAVE_ADDR1, bus->slave->addr,
> + true);
I would leave this on one line.
> +#endif
...
> +static void npcm_i2c_write_fifo_slave(struct npcm_i2c *bus, u16 max_bytes)
> +{
> + u8 size_free_fifo;
+ blank line.
> + /*
> + * Fill the FIFO, while the FIFO is not full and there are more bytes
> + * to write
> + */
> + npcm_i2c_clear_fifo_int(bus);
> + npcm_i2c_clear_tx_fifo(bus);
> + iowrite8(0, bus->reg + NPCM_I2CTXF_CTL);
> + size_free_fifo = I2C_HW_FIFO_SIZE - npcm_i2c_fifo_usage(bus);
Dup, move into loop.
> + while (max_bytes-- && size_free_fifo) {
> + if (bus->slv_wr_size > 0) {
> + bus->slv_wr_ind = bus->slv_wr_ind % I2C_HW_FIFO_SIZE;
> + npcm_i2c_wr_byte(bus, bus->slv_wr_buf[bus->slv_wr_ind]);
> + bus->slv_wr_ind++;
> + bus->slv_wr_ind = bus->slv_wr_ind % I2C_HW_FIFO_SIZE;
> + bus->slv_wr_size--;
> + size_free_fifo = I2C_HW_FIFO_SIZE -
> + npcm_i2c_fifo_usage(bus);
> + } else {
> + break;
> + }
> + }
while (...) {
if (...)
break;
...
}
> +}
...
> +static int npcm_i2c_slave_get_wr_buf(struct npcm_i2c *bus)
> +{
> + int i;
> + u8 value = 0;
Redundant assignment.
> + int ind;
> + int ret = bus->slv_wr_ind;
> +
> + /* fill a cyclic buffer */
> + for (i = 0; i < I2C_HW_FIFO_SIZE; i++) {
> + if (bus->slv_wr_size >= I2C_HW_FIFO_SIZE)
> + break;
> + i2c_slave_event(bus->slave, I2C_SLAVE_READ_REQUESTED, &value);
> + ind = (bus->slv_wr_ind + bus->slv_wr_size) % I2C_HW_FIFO_SIZE;
> + bus->slv_wr_buf[ind] = value;
> + bus->slv_wr_size++;
> + i2c_slave_event(bus->slave, I2C_SLAVE_READ_PROCESSED, &value);
> + }
> + return I2C_HW_FIFO_SIZE - ret;
> +}
--
With Best Regards,
Andy Shevchenko
