On 5/27/20 9:52 AM, Serge Semin wrote: > On Wed, May 27, 2020 at 09:25:49AM -0700, Guenter Roeck wrote: >> On Tue, May 26, 2020 at 04:38:23PM +0300, Serge Semin wrote: > > [nip] > >>> + >>> +=============================== ======= >>> ======================================= >>> +Name Perm Description >>> +=============================== ======= >>> ======================================= >>> +update_interval RW Measurements update interval per >>> + sensor. >>> +temp1_type RO Sensor type (always 1 as CPU embedded >>> + diode). >>> +temp1_label RO CPU Core Temperature sensor. >>> +temp1_input RO Measured temperature in >>> millidegree >>> + Celsius. >>> +temp1_min RW Low limit for temp input. >>> +temp1_max RW High limit for temp input. >>> +temp1_min_alarm RO Temperature input alarm. >>> Returns 1 if >>> + temperature input went below min limit, >>> + 0 otherwise. >>> +temp1_max_alarm RO Temperature input alarm. >>> Returns 1 if >>> + temperature input went above max limit, >>> + 0 otherwise. >>> +temp1_trim RW Temperature sensor trimming factor in >>> + millidegree Celsius. It can be used to >>> + manually adjust the temperature >>> + measurements within 7.130 degrees >>> + Celsius. >> >> vs. standard ABI: >> >> temp[1-*]_offset` >> Temperature offset which is added to the temperature reading >> by the chip. >> >> Unit: millidegree Celsius >> >> If you really think this is necessary, why not use the standard ABI ? > > That would have made much more sense.) I'll replace the handwritten temp1_trim > with the standard temp1_offset attribute in v4 shortly today. Thanks for > pointing > this out. >
Sorry for not realizing this earlier. The added explanation made all the difference. Guenter
