Hi Philipp, Thank you very much for review comments and your time...
On 9/6/2020 8:14 pm, Philipp Zabel wrote:
+ + for (i = 0; i < ARRAY_SIZE(CTL_RESETS); i++) { + resets[i] = devm_reset_control_get(dev, CTL_RESETS[i]);Please use devm_reset_control_get_exclusive() instead.
Noted, will use it.
+ if (IS_ERR(resets[i])) { + dev_err(dev, "%s reset not found\n", CTL_RESETS[i]); + return PTR_ERR(resets[i]); + } + reset_control_assert(resets[i]); + }You should request all reset controls first, and only then start asserting / deasserting, otherwise you may end up with partially asserted resets in case a later reset control is not found.
Agreed!, re-write the assert/de-assert logic as you have suggested.
+ + for (i = 0; i < ARRAY_SIZE(PHY_RESETS); i++) { + ta->resets[i] = devm_reset_control_get(dev, PHY_RESETS[i]);Same as above.+ if (IS_ERR(ta->resets[i])) { + dev_err(dev, "%s reset not found\n", PHY_RESETS[i]); + return PTR_ERR(ta->resets[i]); + } + reset_control_assert(ta->resets[i]); + } + + for (i = 0; i < ARRAY_SIZE(CTL_RESETS); i++) + reset_control_deassert(resets[i]); + /* Need to wait at least 20us before de-assert the PHY */ + usleep_range(20, 100);This waits 20us after de-asserting the reset, not before. Is this in the correct place?
yes, you are right, it's in wrong place, Thanks! Regards Vadivel
