Thanks Doug,
Overall the patch is looking good, I have few minor comments below!
On 17/06/2020 15:51, Douglas Anderson wrote:
From: Ravi Kumar Bokka <[email protected]>
This patch adds support for blowing fuses to the qfprom driver if the
required properties are defined in the device tree.
Signed-off-by: Ravi Kumar Bokka <[email protected]>
Signed-off-by: Douglas Anderson <[email protected]>
---
Please double-check that I got the major/minor version logic right
here. I don't have documentation for this, but Srinivas mentioned
that it was at address 0x6000 and I happened to find an "8" and a "7"
on sc7180 so I assumed that was the major and minor version.
Changes in v3:
- Don't provide "reset" value for things; just save/restore.
- Use the major/minor version read from 0x6000.
- Reading should still read "corrected", not "raw".
- Added a sysfs knob to allow you to read "raw" instead of "corrected"
- Simplified the SoC data structure.
- No need for quite so many levels of abstraction for clocks/regulator.
- Don't set regulator voltage. Rely on device tree to make sure it's right.
- Properly undo things in the case of failure.
- Don't just keep enabling the regulator over and over again.
- Enable / disable the clock each time
- Polling every 100 us but timing out in 10 us didn't make sense; swap.
- No reason for 100 us to be SoC specific.
- No need for reg-names.
- We shouldn't be creating two separate nvmem devices.
drivers/nvmem/qfprom.c | 314 +++++++++++++++++++++++++++++++++++++++--
1 file changed, 303 insertions(+), 11 deletions(-)
diff --git a/drivers/nvmem/qfprom.c b/drivers/nvmem/qfprom.c
index 8a91717600be..486202860f84 100644
--- a/drivers/nvmem/qfprom.c
+++ b/drivers/nvmem/qfprom.c
@@ -3,57 +3,349 @@
* Copyright (C) 2015 Srinivas Kandagatla <[email protected]>
*/
+#include <linux/clk.h>
#include <linux/device.h>
+#include <linux/io.h>
+#include <linux/iopoll.h>
+#include <linux/kernel.h>
#include <linux/module.h>
#include <linux/mod_devicetable.h>
-#include <linux/io.h>
#include <linux/nvmem-provider.h>
#include <linux/platform_device.h>
+#include <linux/regulator/consumer.h>
+
+/* Blow timer clock frequency in Mhz */
+#define QFPROM_BLOW_TIMER_OFFSET 0x03c
+
+/* Amount of time required to hold charge to blow fuse in micro-seconds */
+#define QFPROM_FUSE_BLOW_POLL_US 10
+#define QFPROM_FUSE_BLOW_TIMEOUT_US 100
+
+#define QFPROM_BLOW_STATUS_OFFSET 0x048
+#define QFPROM_BLOW_STATUS_BUSY 0x1
+#define QFPROM_BLOW_STATUS_READY 0x0
+
+#define QFPROM_ACCEL_OFFSET 0x044
+
+#define QFPROM_VERSION_OFFSET 0x0
+#define QFPROM_MAJOR_VERSION_SHIFT 28
+#define QFPROM_MAJOR_VERSION_MASK 0xf
+#define QFPROM_MINOR_VERSION_SHIFT 16
+#define QFPROM_MINOR_VERSION_MASK 0xf
Using GENMASK here makes it much readable!
...
static int qfprom_probe(struct platform_device *pdev)
{
+ struct nvmem_config econfig = {
+ .name = "qfprom",
+ .stride = 1,
+ .word_size = 1,
+ .reg_read = qfprom_reg_read,
+ };
struct device *dev = &pdev->dev;
struct resource *res;
struct nvmem_device *nvmem;
struct qfprom_priv *priv;
+ int ret;
priv = devm_kzalloc(dev, sizeof(*priv), GFP_KERNEL);
if (!priv)
return -ENOMEM;
+ /* The corrected section is always provided */
res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
- priv->base = devm_ioremap_resource(dev, res);
- if (IS_ERR(priv->base))
- return PTR_ERR(priv->base);
+ priv->qfpcorrected = devm_ioremap_resource(dev, res);
+ if (IS_ERR(priv->qfpcorrected))
+ return PTR_ERR(priv->qfpcorrected);
econfig.size = resource_size(res);
econfig.dev = dev;
econfig.priv = priv;
+ priv->dev = dev;
+
+ /*
+ * If more than one region is provided then the OS has the ability
+ * to write.
+ */
+ res = platform_get_resource(pdev, IORESOURCE_MEM, 1);
+ if (res) {
+ u32 version;
+ int major_version, minor_version;
+
+ priv->qfpraw = devm_ioremap_resource(dev, res);
+ if (IS_ERR(priv->qfpraw))
+ return PTR_ERR(priv->qfpraw);
+ res = platform_get_resource(pdev, IORESOURCE_MEM, 2);
+ priv->qfpconf = devm_ioremap_resource(dev, res);
+ if (IS_ERR(priv->qfpconf))
+ return PTR_ERR(priv->qfpconf);
+ res = platform_get_resource(pdev, IORESOURCE_MEM, 3);
+ priv->qfpsecurity = devm_ioremap_resource(dev, res);
+ if (IS_ERR(priv->qfpsecurity))
+ return PTR_ERR(priv->qfpsecurity);
+
+ version = readl(priv->qfpsecurity + QFPROM_VERSION_OFFSET);
+ major_version = (version >> QFPROM_MAJOR_VERSION_SHIFT) &
+ QFPROM_MAJOR_VERSION_MASK;
+ minor_version = (version >> QFPROM_MINOR_VERSION_SHIFT) &
+ QFPROM_MINOR_VERSION_MASK;
+
+ if (major_version == 7 && minor_version == 8)
+ priv->soc_data = &qfprom_7_8_data;
+
+ /* Only enable writing if we have SoC data. */
+ if (priv->soc_data)
+ econfig.reg_write = qfprom_reg_write;
+ }
+
<----------snip
+ priv->vcc = devm_regulator_get(&pdev->dev, "vcc");
+ if (IS_ERR(priv->vcc))
+ return PTR_ERR(priv->vcc);
+
+ priv->secclk = devm_clk_get_optional(dev, "sec");
+ if (IS_ERR(priv->secclk)) {
+ ret = PTR_ERR(priv->secclk);
+ if (ret != -EPROBE_DEFER)
+ dev_err(dev, "sec error getting : %d\n", ret);
+ return ret;
+ }
+
----------->
should you move both clk and regulator into the previous if (res) {}
block? As I don't see them marked as optional for write cases.
nvmem = devm_nvmem_register(dev, &econfig);
return PTR_ERR_OR_ZERO(nvmem);
