On Fri, 2020-06-19 at 16:06 +0800, Qiangming Xia wrote:
> From: "qiangming.xia" <qiangming....@mediatek.com>
>
> Mediatek i2c controller support for continuous mode,
> it allow to transfer once multiple writing messages of equal length.
> For example, a slave need write a serial of non-continuous
> offset range in chip,e.g. writing offset 0,offset 2 and offset 4.
> Normally, it need three times i2c write operation. However,it can
> use once transfer to finish it by using continuous mode.
>
> Change-Id: If06991e3fd32867bdeaacf15bb24864d5c5904d0
> Signed-off-by: Qiangming Xia <qiangming....@mediatek.com>
> ---
> drivers/i2c/busses/i2c-mt65xx.c | 67 +++++++++++++++++++++++++++++++++
> 1 file changed, 67 insertions(+)
>
> diff --git a/drivers/i2c/busses/i2c-mt65xx.c b/drivers/i2c/busses/i2c-mt65xx.c
> index deef69e56906..76ec65d869f6 100644
> --- a/drivers/i2c/busses/i2c-mt65xx.c
> +++ b/drivers/i2c/busses/i2c-mt65xx.c
> @@ -97,6 +97,7 @@ enum mtk_trans_op {
> I2C_MASTER_WR = 1,
> I2C_MASTER_RD,
> I2C_MASTER_WRRD,
> + I2C_MASTER_CONTINUOUS_WR,
> };
>
> enum I2C_REGS_OFFSET {
> @@ -846,6 +847,9 @@ static int mtk_i2c_do_transfer(struct mtk_i2c *i2c,
> struct i2c_msg *msgs,
> OFFSET_TRANSFER_LEN);
> }
> mtk_i2c_writew(i2c, I2C_WRRD_TRANAC_VALUE, OFFSET_TRANSAC_LEN);
> + } else if (i2c->op == I2C_MASTER_CONTINUOUS_WR) {
> + mtk_i2c_writew(i2c, msgs->len / num, OFFSET_TRANSFER_LEN);
> + mtk_i2c_writew(i2c, num, OFFSET_TRANSAC_LEN);
> } else {
> mtk_i2c_writew(i2c, msgs->len, OFFSET_TRANSFER_LEN);
> mtk_i2c_writew(i2c, num, OFFSET_TRANSAC_LEN);
> @@ -896,6 +900,23 @@ static int mtk_i2c_do_transfer(struct mtk_i2c *i2c,
> struct i2c_msg *msgs,
> writel(reg_4g_mode, i2c->pdmabase + OFFSET_TX_4G_MODE);
> }
>
> + writel((u32)wpaddr, i2c->pdmabase + OFFSET_TX_MEM_ADDR);
> + writel(msgs->len, i2c->pdmabase + OFFSET_TX_LEN);
> + } else if (i2c->op == I2C_MASTER_CONTINUOUS_WR) {
> + writel(I2C_DMA_INT_FLAG_NONE, i2c->pdmabase + OFFSET_INT_FLAG);
> + writel(I2C_DMA_CON_TX, i2c->pdmabase + OFFSET_CON);
> + wpaddr = dma_map_single(i2c->dev, msgs->buf,
> + msgs->len, DMA_TO_DEVICE);
> + if (dma_mapping_error(i2c->dev, wpaddr)) {
> + kfree(msgs->buf);
> + return -ENOMEM;
> + }
> +
> + if (i2c->dev_comp->support_33bits) {
> + reg_4g_mode = mtk_i2c_set_4g_mode(wpaddr);
> + writel(reg_4g_mode, i2c->pdmabase + OFFSET_TX_4G_MODE);
> + }
> +
> writel((u32)wpaddr, i2c->pdmabase + OFFSET_TX_MEM_ADDR);
> writel(msgs->len, i2c->pdmabase + OFFSET_TX_LEN);
> } else {
> @@ -979,6 +1000,11 @@ static int mtk_i2c_do_transfer(struct mtk_i2c *i2c,
> struct i2c_msg *msgs,
> msgs->len, DMA_FROM_DEVICE);
>
> i2c_put_dma_safe_msg_buf(dma_rd_buf, msgs, true);
> + } else if (i2c->op == I2C_MASTER_CONTINUOUS_WR) {
> + dma_unmap_single(i2c->dev, wpaddr,
> + msgs->len, DMA_TO_DEVICE);
> +
> + kfree(msgs->buf);
> } else {
> dma_unmap_single(i2c->dev, wpaddr, msgs->len,
> DMA_TO_DEVICE);
> @@ -1009,6 +1035,9 @@ static int mtk_i2c_transfer(struct i2c_adapter *adap,
> {
> int ret;
> int left_num = num;
> + int i, j;
> + u8 *dma_multi_wr_buf;
> + struct i2c_msg multi_msg[1];
> struct mtk_i2c *i2c = i2c_get_adapdata(adap);
>
> ret = mtk_i2c_clock_enable(i2c);
> @@ -1025,6 +1054,44 @@ static int mtk_i2c_transfer(struct i2c_adapter *adap,
> }
> }
>
> + if (num > 1) {
> + for (i = 0; i < num - 1; i++) {
> + if (!(msgs[i].flags & I2C_M_RD) && !(msgs[i+1].flags &
> + I2C_M_RD) && (msgs[i].addr == msgs[i+1].addr)
> + && (msgs[i].len == msgs[i+1].len)) {
if these conditions are not met, Can these transfers work?
> + continue;
> + } else
> + break;
> + }
> + if (i >= num - 1) {
> + i2c->op = I2C_MASTER_CONTINUOUS_WR;
> + j = 0;
> + dma_multi_wr_buf = kzalloc(msgs->len * num, GFP_KERNEL);
> + if (!dma_multi_wr_buf) {
> + ret = -ENOMEM;
> + goto err_exit;
> + }
> + multi_msg->addr = msgs->addr;
> + multi_msg->len = msgs->len * num;
> + multi_msg->buf = dma_multi_wr_buf;
> + multi_msg->flags = 0;
> + while (j < num) {
> + memcpy(dma_multi_wr_buf + msgs->len * j,
> + msgs->buf, msgs->len);
> + j++;
> + msgs++;
> + }
> +
> + i2c->ignore_restart_irq = false;
> + ret = mtk_i2c_do_transfer(i2c, multi_msg, num, 0);
> + if (ret < 0)
> + goto err_exit;
> + ret = num;
> + goto err_exit;
> +
> + }
> + }
> +
> if (i2c->auto_restart && num >= 2 && i2c->speed_hz >
> I2C_MAX_FAST_MODE_FREQ)
> /* ignore the first restart irq after the master code,
> * otherwise the first transfer will be discarded.
