On Thu, Jun 18, 2020 at 04:43:37PM +0300, amirmi...@gmail.com wrote: > From: Amir Mizinski <amirmi...@gmail.com> > > Detected the following incorrect implementation of the send command: > polling on the TPM_STS.stsValid field followed by checking the > TPM_STS.expect field only once. Since TPM_STS.stsValid represents the > TPM_STS.expect validity, both fields should be polled at the same time. > > This fix modifies the signature of wait_for_tpm_stat(), adding an > additional "mask_result" parameter to its call. wait_for_tpm_stat() is now > polling the TPM_STS with a mask and waits for the value in mask_result. > The fix adds the ability to check if certain TPM_STS bits have been > cleared. > > This change is also aligned to verifying the CRC on I2C TPM. The CRC > verification should be done after the TPM_STS.expect field is cleared > (TPM received all expected command bytes and set the calculated CRC value > in the register). > > In addition, the send command was changed to comply with > TCG_DesignPrinciples_TPM2p0Driver_vp24_pubrev.pdf as follows: > - send all command bytes in one loop > - remove special handling of the last byte > > Suggested-by: Benoit Houyere <benoit.houy...@st.com> > Signed-off-by: Amir Mizinski <amirmi...@gmail.com>
Reviewed-by: Jarkko Sakkinen <jarkko.sakki...@linux.intel.com> If this patch set needs a further update, you could rename the function as 'tpm_tis_wait_for_stat()' (can be part of this patch). It's better aligned with other naming and gives better picture of the scope of this function. /Jarkko
