Add the internal delay values into the header and update the binding with the internal delay properties.
Signed-off-by: Dan Murphy <dmur...@ti.com> --- .../devicetree/bindings/net/ti,dp83869.yaml | 16 +++++++++++++++- 1 file changed, 15 insertions(+), 1 deletion(-) diff --git a/Documentation/devicetree/bindings/net/ti,dp83869.yaml b/Documentation/devicetree/bindings/net/ti,dp83869.yaml index 5b69ef03bbf7..71e90a3e4652 100644 --- a/Documentation/devicetree/bindings/net/ti,dp83869.yaml +++ b/Documentation/devicetree/bindings/net/ti,dp83869.yaml @@ -8,7 +8,7 @@ $schema: "http://devicetree.org/meta-schemas/core.yaml#"; title: TI DP83869 ethernet PHY allOf: - - $ref: "ethernet-controller.yaml#" + - $ref: "ethernet-phy.yaml#" maintainers: - Dan Murphy <dmur...@ti.com> @@ -64,6 +64,18 @@ properties: Operational mode for the PHY. If this is not set then the operational mode is set by the straps. see dt-bindings/net/ti-dp83869.h for values + rx-internal-delay-ps: + description: Delay is in pico seconds + enum: [ 250, 500, 750, 1000, 1250, 1500, 1750, 2000, 2250, 2500, 2750, 3000, + 3250, 3500, 3750, 4000 ] + default: 2000 + + tx-internal-delay-ps: + description: Delay is in pico seconds + enum: [ 250, 500, 750, 1000, 1250, 1500, 1750, 2000, 2250, 2500, 2750, 3000, + 3250, 3500, 3750, 4000 ] + default: 2000 + required: - reg @@ -80,5 +92,7 @@ examples: ti,op-mode = <DP83869_RGMII_COPPER_ETHERNET>; ti,max-output-impedance = "true"; ti,clk-output-sel = <DP83869_CLK_O_SEL_CHN_A_RCLK>; + rx-internal-delay-ps = <2000>; + tx-internal-delay-ps = <2000>; }; }; -- 2.26.2
