On Fri, 2020-05-22 at 17:32 +0200, Daniel Lezcano wrote:
> On 23/03/2020 13:15, Michael Kao wrote:
> > Provide thermal zone to read thermal sensor
> > in the SoC. We can read all the thermal sensors
> > value in the SoC by the node /sys/class/thermal/
> >
> > In mtk_thermal_bank_temperature, return -EAGAIN instead of -EACCESS
> > on the first read of sensor that often are bogus values.
> > This can avoid following warning on boot:
> >
> > thermal thermal_zone6: failed to read out thermal zone (-13)
>
> What the source problem of the sensor returning bogus values?
> The thermal controller will depend on the AUXADC module to read raw data from
> sensor.
Sometimes it will report wrong value because the AUXADC not ready or
other issue.
The thermal driver should add the judgement to prevent wrong temperature
value to cause
system immediately shut down.
>
> > Signed-off-by: Michael Kao <michael....@mediatek.com>
> > Signed-off-by: Hsin-Yi Wang <hsi...@chromium.org>
> > ---
> > drivers/thermal/mtk_thermal.c | 74 +++++++++++++++++++++++++++++++----
> > 1 file changed, 67 insertions(+), 7 deletions(-)
> >
> > diff --git a/drivers/thermal/mtk_thermal.c b/drivers/thermal/mtk_thermal.c
> > index 6b7ef1993d7e..9eaca432920e 100644
> > --- a/drivers/thermal/mtk_thermal.c
> > +++ b/drivers/thermal/mtk_thermal.c
> > @@ -225,6 +225,11 @@ enum {
> >
> > struct mtk_thermal;
> >
> > +struct mtk_thermal_zone {
> > + struct mtk_thermal *mt;
> > + int id;
> > +};
> > +
> > struct thermal_bank_cfg {
> > unsigned int num_sensors;
> > const int *sensors;
> > @@ -607,7 +612,7 @@ static int mtk_thermal_bank_temperature(struct
> > mtk_thermal_bank *bank)
> > * not immediately shut down.
> > */
> > if (temp > 200000)
> > - temp = 0;
> > + temp = -EAGAIN;
> >
> > if (temp > max)
> > max = temp;
> > @@ -618,7 +623,8 @@ static int mtk_thermal_bank_temperature(struct
> > mtk_thermal_bank *bank)
> >
> > static int mtk_read_temp(void *data, int *temperature)
> > {
> > - struct mtk_thermal *mt = data;
> > + struct mtk_thermal_zone *tz = data;
> > + struct mtk_thermal *mt = tz->mt;
> > int i;
> > int tempmax = INT_MIN;
> >
> > @@ -637,10 +643,44 @@ static int mtk_read_temp(void *data, int *temperature)
> > return 0;
> > }
> >
> > +static int mtk_read_sensor_temp(void *data, int *temperature)
> > +{
> > + struct mtk_thermal_zone *tz = data;
> > + struct mtk_thermal *mt = tz->mt;
> > + const struct mtk_thermal_data *conf = mt->conf;
> > + int id = tz->id - 1;
> > + int temp = INT_MIN;
> > + u32 raw;
> > +
> > + if (id < 0)
> > + return -EACCES;
> > +
> > + raw = readl(mt->thermal_base + conf->msr[id]);
> > +
> > + temp = raw_to_mcelsius(mt, id, raw);
> > +
> > + /*
> > + * The first read of a sensor often contains very high bogus
> > + * temperature value. Filter these out so that the system does
> > + * not immediately shut down.
> > + */
> > +
> > + if (temp > 200000)
> > + return -EAGAIN;
> > +
> > + *temperature = temp;
> > +
> > + return 0;
> > +}
> > +
> > static const struct thermal_zone_of_device_ops mtk_thermal_ops = {
> > .get_temp = mtk_read_temp,
> > };
> >
> > +static const struct thermal_zone_of_device_ops mtk_thermal_sensor_ops = {
> > + .get_temp = mtk_read_sensor_temp,
> > +};
> > +
> > static void mtk_thermal_init_bank(struct mtk_thermal *mt, int num,
> > u32 apmixed_phys_base, u32 auxadc_phys_base,
> > int ctrl_id)
> > @@ -873,6 +913,7 @@ static int mtk_thermal_probe(struct platform_device
> > *pdev)
> > struct resource *res;
> > u64 auxadc_phys_base, apmixed_phys_base;
> > struct thermal_zone_device *tzdev;
> > + struct mtk_thermal_zone *tz;
> >
> > mt = devm_kzalloc(&pdev->dev, sizeof(*mt), GFP_KERNEL);
> > if (!mt)
> > @@ -954,11 +995,30 @@ static int mtk_thermal_probe(struct platform_device
> > *pdev)
> >
> > platform_set_drvdata(pdev, mt);
> >
> > - tzdev = devm_thermal_zone_of_sensor_register(&pdev->dev, 0, mt,
> > - &mtk_thermal_ops);
> > - if (IS_ERR(tzdev)) {
> > - ret = PTR_ERR(tzdev);
> > - goto err_disable_clk_peri_therm;
> > + for (i = 0; i < mt->conf->num_sensors + 1; i++) {
> > + tz = kmalloc(sizeof(*tz), GFP_KERNEL);
> > + if (!tz)
> > + return -ENOMEM;
> > +
> > + tz->mt = mt;
> > + tz->id = i;
> > +
> > + tzdev = devm_thermal_zone_of_sensor_register(&pdev->dev, i,
> > + tz, (i == 0) ?
> > + &mtk_thermal_ops : &mtk_thermal_sensor_ops);
> > +
> > + if (IS_ERR(tzdev)) {
> > + if (PTR_ERR(tzdev) == -ENODEV) {
> > + dev_warn(&pdev->dev,
> > + "sensor %d not registered in thermal
> > zone in dt\n",
> > + i);
> > + continue;
> > + }
> > + if (PTR_ERR(tzdev) == -EACCES) {
> > + ret = PTR_ERR(tzdev);
> > + goto err_disable_clk_peri_therm;
> > + }
> > + }
> > }
> >
> > return 0;
> >
>
>
