Pavel
On 8/11/20 5:01 PM, Pavel Machek wrote:
Hi!
Actually... This is quite impressive ammount of code to
zero-initialize few registers. Could the regmap be told to set the
range to zero, or use loops to reduce ammount of code?
I am not aware of any regmap calls that will set a range of registers to a
certain value.
Well it depends on where we want to create the default cache values.
Either we run through a for..loop during driver probe and delay device start
up or we keep the simple arrays and increase the driver total size.
for loop will be better.
Plus, REGCACHE_RBTREE is very likely overkill.
Well if I eliminate the reg_cache then I can eliminate the defaults too.
Dan
Best regards,
Pavel
