On Wed, Aug 26, 2020 at 02:25:44PM +0900, Sergey Senozhatsky wrote: > On (20/08/26 07:08), Wolfram Sang wrote: > > On Wed, Aug 26, 2020 at 01:29:37PM +0900, Sergey Senozhatsky wrote: > > > Unlike acpi_match_device(), acpi_driver_match_device() does > > > consider devices that provide of_match_table and performs > > > of_compatible() matching for such devices. The key point here is > > > that ACPI of_compatible() matching - acpi_of_match_device() - is > > > part of ACPI and does not depend on CONFIG_OF. > > > > > > Consider the following case: > > > o !CONFIG_OF system > > > o probing of i2c device that provides .of_match_table, but no .id_table > > > > > > i2c_device_probe() > > > ... > > > if (!driver->id_table && > > > !i2c_acpi_match_device(dev->driver->acpi_match_table, client) && > > > !i2c_of_match_device(dev->driver->of_match_table, client)) { > > > status = -ENODEV; > > > goto put_sync_adapter; > > > } > > > > > > i2c_of_match_device() depends on CONFIG_OF and, thus, is always false. > > > i2c_acpi_match_device() does ACPI match only, no of_comtatible() matching > > > takes place, even though the device provides .of_match_table and ACPI, > > > technically, is capable of matching such device. The result is -ENODEV. > > > Probing will succeed, however, if we'd use .of_match_table aware ACPI > > > matching.
Looks like you read same StackOverflow question :-) > > > Signed-off-by: Sergey Senozhatsky <sergey.senozhat...@gmail.com> > > > > We have currently this in for-current which is even removing > > i2c_acpi_match_device(): > > > > http://patchwork.ozlabs.org/project/linux-i2c/list/?series=196990&state=* > > Oh, nice! > Can we go a bit further and use i2c_device_match() in i2c_device_probe() > instead of a mix of APIs from different subsystems? > E.g. > > if (!driver->id_table && > - !i2c_acpi_match_device(dev->driver->acpi_match_table, client) && > - !i2c_of_match_device(dev->driver->of_match_table, client)) { > + !(client && i2c_device_match(&client->dev, dev->driver))) { You probably meant simply: if (!i2c_device_match(dev, dev->driver)) { > status = -ENODEV; > goto put_sync_adapter; > } On the first glance it will work the same way but slightly longer in case of ID table matching. Send a patch! -- With Best Regards, Andy Shevchenko