Add a suitable sleep configuration for uart3 to support Bluetooth wakeup.
If QUP function is selected in sleep state, UART RTS/RFR is pulled high
during suspend and BT SoC not able to send wakeup bytes. So, configure
GPIO mode in sleep state to keep it low during suspend.
Signed-off-by: satya priya <ska...@codeaurora.org>
---
Changes in V5:
- Newly added in V5. This patch adds wakeup support for trogdor board files.
arch/arm64/boot/dts/qcom/sc7180-trogdor.dtsi | 48 ++++++++++++++++++++++++++++
1 file changed, 48 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/sc7180-trogdor.dtsi
b/arch/arm64/boot/dts/qcom/sc7180-trogdor.dtsi
index a6b9beb..96b5331 100644
--- a/arch/arm64/boot/dts/qcom/sc7180-trogdor.dtsi
+++ b/arch/arm64/boot/dts/qcom/sc7180-trogdor.dtsi
@@ -792,6 +792,11 @@ ap_spi_fp: &spi10 {
#include <arm/cros-ec-sbs.dtsi>
&uart3 {
+ pinctrl-names = "default", "sleep";
+ pinctrl-1 = <&qup_uart3_sleep>;
+ interrupts-extended = <&intc GIC_SPI 604 IRQ_TYPE_LEVEL_HIGH>,
+ <&tlmm 41 IRQ_TYPE_EDGE_FALLING>;
+
status = "okay";
bluetooth: bluetooth {
@@ -1345,4 +1350,47 @@ ap_spi_fp: &spi10 {
drive-strength = <2>;
};
};
+
+ qup_uart3_sleep: qup-uart3-sleep {
+ pinmux {
+ pins = "gpio38", "gpio39",
+ "gpio40", "gpio41";
+ function = "gpio";
+ };
+
+ pinconf-cts {
+ /*
+ * Configure a pull-down on CTS to match the pull of
+ * the Bluetooth module.
+ */
+ pins = "gpio38";
+ bias-pull-down;
+ };
+
+ pinconf-rts {
+ /*
+ * Configure pull-down on RTS to make sure that the BT
SoC can
+ * wake up the system by sending wakeup bytes during
suspend.
+ */
+ pins = "gpio39";
+ bias-pull-down;
+ };
+
+ pinconf-tx {
+ /* Configure pull-up on TX when it isn't actively
driven */
+ pins = "gpio40";
+ bias-pull-up;
+ };
+
+ pinconf-rx {
+ /*
+ * Configure a pull-up on RX. This is needed to avoid
+ * garbage data when the TX pin of the Bluetooth module
is
+ * in tri-state (module powered off or not driving the
+ * signal yet).
+ */
+ pins = "gpio41";
+ bias-pull-up;
+ };
+ };
};
--
QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member
of Code Aurora Forum, hosted by The Linux Foundation
