On Mon, Sep 14, 2020 at 09:59:26AM +1200, Chris Packham wrote:
> The ehci controller found in some Broadcom switches with integrated SoCs
> has an issue which causes a soft lockup with large transfers like you
> see when running ext4 on USB3 flash drive.
>
> Port the fix from the Broadcom XLDK to increase the OUT_THRESHOLD to
> avoid the problem.
>
> Signed-off-by: Chris Packham <chris.pack...@alliedtelesis.co.nz>
> ---
>
> I don't have much data on what this change does. I can say it is needed to
> avoid a soft lockup when using a USB3 Flash drive formatted has ext4 (USB2 +
> ext4 is OK, USB3 + fat is OK). I presume the affected combination ends up
> using
> larger transfers triggering the problem.
>
> The equivalent change in the Broadcom XLDK is
>
> if (IS_ENABLED(CONFIG_USB_EHCI_XGS_IPROC))
> ehci_writel(ehci, BCM_USB_FIFO_THRESHOLD,
> &ehci->regs->reserved4[6]);
>
> This is problematic because it would unconditionally apply to all ehci
> controllers whenever CONFIG_USB_EHCI_XGS_IPROC is enabled (also reserved4 only
> goes to 6 so technically it's indexing off the end of the array).
>
> I wasn't sure if I should add a new property or somehow detect the affected
> host controller. I settled on using of_device_is_compatible() as that seemed
> the simplest thing to do.
>
> Changes in v2:
> - move workaround to ehci_platform_reset
> - cosmetic changes suggested by Alan
>
> drivers/usb/host/ehci-platform.c | 8 ++++++++
> 1 file changed, 8 insertions(+)
>
> diff --git a/drivers/usb/host/ehci-platform.c
> b/drivers/usb/host/ehci-platform.c
> index 006c4f6188a5..9804ffa9e67f 100644
> --- a/drivers/usb/host/ehci-platform.c
> +++ b/drivers/usb/host/ehci-platform.c
> @@ -42,6 +42,9 @@
> #define EHCI_MAX_CLKS 4
> #define hcd_to_ehci_priv(h) ((struct ehci_platform_priv
> *)hcd_to_ehci(h)->priv)
>
> +#define BCM_USB_FIFO_THRESHOLD 0x00800040
> +#define bcm_iproc_insnreg01 hostpc[0]
> +
> struct ehci_platform_priv {
> struct clk *clks[EHCI_MAX_CLKS];
> struct reset_control *rsts;
> @@ -75,6 +78,11 @@ static int ehci_platform_reset(struct usb_hcd *hcd)
>
> if (pdata->no_io_watchdog)
> ehci->need_io_watchdog = 0;
> +
> + if (of_device_is_compatible(pdev->dev.of_node, "brcm,xgs-iproc-ehci"))
> + ehci_writel(ehci, BCM_USB_FIFO_THRESHOLD,
> + &ehci->regs->bcm_iproc_insnreg01);
> +
> return 0;
> }
Acked-by: Alan Stern <st...@rowland.harvard.edu>
