On Wed, Jul 22, 2020 at 02:49:49PM +0000, Alex Belits wrote:
> +/**
> + * task_isolation_kernel_enter() - clear low-level task isolation flag
> + *
> + * This should be called immediately after entering kernel.
> + */
> +static inline void task_isolation_kernel_enter(void)
> +{
> + unsigned long flags;
> +
> + /*
> + * This function runs on a CPU that ran isolated task.
> + *
> + * We don't want this CPU running code from the rest of kernel
> + * until other CPUs know that it is no longer isolated.
> + * When CPU is running isolated task until this point anything
> + * that causes an interrupt on this CPU must end up calling this
> + * before touching the rest of kernel. That is, this function or
> + * fast_task_isolation_cpu_cleanup() or stop_isolation() calling
> + * it. If any interrupt, including scheduling timer, arrives, it
> + * will still end up here early after entering kernel.
> + * From this point interrupts are disabled until all CPUs will see
> + * that this CPU is no longer running isolated task.
> + *
> + * See also fast_task_isolation_cpu_cleanup().
> + */
> + smp_rmb();
I'm a bit confused what this read memory barrier is ordering. Also against
what it pairs.
> + if((this_cpu_read(ll_isol_flags) & FLAG_LL_TASK_ISOLATION) == 0)
> + return;
> +
> + local_irq_save(flags);
> +
> + /* Clear low-level flags */
> + this_cpu_write(ll_isol_flags, 0);
> +
> + /*
> + * If something happened that requires a barrier that would
> + * otherwise be called from remote CPUs by CPU kick procedure,
> + * this barrier runs instead of it. After this barrier, CPU
> + * kick procedure would see the updated ll_isol_flags, so it
> + * will run its own IPI to trigger a barrier.
> + */
> + smp_mb();
> + /*
> + * Synchronize instructions -- this CPU was not kicked while
> + * in isolated mode, so it might require synchronization.
> + * There might be an IPI if kick procedure happened and
> + * ll_isol_flags was already updated while it assembled a CPU
> + * mask. However if this did not happen, synchronize everything
> + * here.
> + */
> + instr_sync();
It's the first time I meet an instruction barrier. I should get information
about that but what is it ordering here?
> + local_irq_restore(flags);
> +}
Thanks.
