Just built a new system with Linux-2.4.0.
Motherboard (MSI 694D-AR) has Via Apollo Pro chipset, those IDE drives seem
fine. Board also has a promise PDC20265 RAID/ATA100 controller. On each
channel of this controller I have an IBM 45 GB ATA100 drive as master.
(hde and hdg?). BIOS sees these drives fine. Linux only see hde and never
hdg (ide[012] but not ide3). I thought I'd post it here, in case anyone
else knew the answer right away.
Second question: Does the RAID functionality of this device work under
linux? If so, is it better than LVM or MD?
boot snippet:
---------------
VP_IDE: IDE controller on PCI bus 00 dev 39
VP_IDE: chipset revision 16
VP_IDE: not 100% native mode: will probe irqs later
VP_IDE: VIA vt82c686a IDE UDMA66 controller on pci0:7.1
ide0: BM-DMA at 0xc000-0xc007, BIOS settings: hda:DMA, hdb:pio
ide1: BM-DMA at 0xc008-0xc00f, BIOS settings: hdc:DMA, hdd:pio
PDC20265: IDE controller on PCI bus 00 dev 60
PDC20265: chipset revision 2
PDC20265: not 100% native mode: will probe irqs later
PDC20265: (U)DMA Burst Bit ENABLED Primary MASTER Mode Secondary MASTER
Mode.
ide2: BM-DMA at 0xdc00-0xdc07, BIOS settings: hde:pio, hdf:pio
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
Please read the FAQ at http://www.tux.org/lkml/
