Intel C440GX+ with on-board Adaptec AIC-7896 fails to boot 2.4.0:
SCSI bus is being reset for host 0 channel 0
SCSI host 0 channel 0 reset (pid 0) timed out - trying harder
... ad infinitum ...
In contrast, this is what I get from the 2.2.17 boot:
(scsi0) <Adaptec AIC-7896/7 Ultra2 SCSI host adapter> found at PCI 0/12/0
(scsi0) Wide Channel A, SCSI ID=7, 32/255 SCBs
(scsi0) Downloading sequencer code... 392 instructions downloaded
(scsi1) <Adaptec AIC-7896/7 Ultra2 SCSI host adapter> found at PCI 0/12/1
(scsi1) Wide Channel B, SCSI ID=7, 32/255 SCBs
(scsi1) Downloading sequencer code... 392 instructions downloaded
scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.1.31/3.2.4
<Adaptec AIC-7896/7 Ultra2 SCSI host adapter>
scsi1 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.1.31/3.2.4
<Adaptec AIC-7896/7 Ultra2 SCSI host adapter>
scsi2 : SCSI host adapter emulation for IDE ATAPI devices
scsi : 3 hosts.
(scsi0:0:0:0) Synchronous at 40.0 Mbyte/sec, offset 31.
Vendor: IBM Model: DNES-309170W Rev: SA30
Type: Direct-Access ANSI SCSI revision: 03
Detected scsi disk sda at scsi0, channel 0, id 0, lun 0
(scsi0:0:6:0) Synchronous at 10.0 Mbyte/sec, offset 15.
Vendor: SONY Model: CD-R CDU948S Rev: 1.0j
Type: CD-ROM ANSI SCSI revision: 02
Detected scsi CD-ROM sr0 at scsi0, channel 0, id 6, lun 0
Vendor: Model: ATAPI CDROM Rev: 120N
Type: CD-ROM ANSI SCSI revision: 02
Detected scsi CD-ROM sr1 at scsi2, channel 0, id 0, lun 0
scsi : detected 3 SCSI generics 2 SCSI cdroms 1 SCSI disk total.
Any quick hint what to try?
-Igor Mozetic
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
Please read the FAQ at http://www.tux.org/lkml/
