[PATCH 2/2] media: rdacm20: Enable GPIO1 explicitly

[Jacopo Mondi]

The MAX9271 GPIO1 line that controls the sensor reset is by default
enabled after a serializer chip reset.

As rdacm20 does not go through an explicit serializer reset, make sure
GPIO1 is enabled to make the camera module driver more robust.

Fixes: 34009bffc1c6 ("media: i2c: Add RDACM20 driver")
Signed-off-by: Jacopo Mondi <jacopo+rene...@jmondi.org>
---
 drivers/media/i2c/rdacm20.c | 13 +++++++++++--
 1 file changed, 11 insertions(+), 2 deletions(-)

diff --git a/drivers/media/i2c/rdacm20.c b/drivers/media/i2c/rdacm20.c
index 1ed928c4ca70..16bcb764b0e0 100644
--- a/drivers/media/i2c/rdacm20.c
+++ b/drivers/media/i2c/rdacm20.c
@@ -487,9 +487,18 @@ static int rdacm20_initialize(struct rdacm20_device *dev)
         * Reset the sensor by cycling the OV10635 reset signal connected to the
         * MAX9271 GPIO1 and verify communication with the OV10635.
         */
-       max9271_clear_gpios(dev->serializer, MAX9271_GPIO1OUT);
+       ret = max9271_enable_gpios(dev->serializer, MAX9271_GPIO1OUT);
+       if (ret)
+               return ret;
+
+       ret = max9271_clear_gpios(dev->serializer, MAX9271_GPIO1OUT);
+       if (ret)
+               return ret;
        usleep_range(10000, 15000);
-       max9271_set_gpios(dev->serializer, MAX9271_GPIO1OUT);
+
+       ret = max9271_set_gpios(dev->serializer, MAX9271_GPIO1OUT);
+       if (ret)
+               return ret;
        usleep_range(10000, 15000);

 again:
--
2.29.1