From: Marek Vasut <[email protected]>
[ Upstream commit 52d9edbe6efc5042cf57fae6a25d07572ddf398b ]
On the prototype DHCOM, the TA3-GPIO-C button was connected to pin PI11 of
the STM32MP15xx, however on the production SoM this was changed to pin PG0
to free up the IRQ line 11 for LAN8710i PHY IRQ. Update the connection in
the DT. Since the IRQ line 0 is used for PMIC as well and cannot be shared
with the button, make the button polled.
Fixes: 87cabf9405cb ("ARM: dts: stm32: Add GPIO keys for STM32MP1 DHCOM PDK2")
Signed-off-by: Marek Vasut <[email protected]>
Cc: Alexandre Torgue <[email protected]>
Cc: Maxime Coquelin <[email protected]>
Cc: Patrice Chotard <[email protected]>
Cc: Patrick Delaunay <[email protected]>
Cc: [email protected]
To: [email protected]
Signed-off-by: Alexandre Torgue <[email protected]>
Signed-off-by: Sasha Levin <[email protected]>
---
arch/arm/boot/dts/stm32mp15xx-dhcom-pdk2.dtsi | 17 ++++++++++-------
1 file changed, 10 insertions(+), 7 deletions(-)
diff --git a/arch/arm/boot/dts/stm32mp15xx-dhcom-pdk2.dtsi
b/arch/arm/boot/dts/stm32mp15xx-dhcom-pdk2.dtsi
index e4e3c92eb30d3..7cddeb1a545a3 100644
--- a/arch/arm/boot/dts/stm32mp15xx-dhcom-pdk2.dtsi
+++ b/arch/arm/boot/dts/stm32mp15xx-dhcom-pdk2.dtsi
@@ -46,6 +46,16 @@
linux,code = <KEY_A>;
gpios = <&gpiof 3 GPIO_ACTIVE_LOW>;
};
+
+ /*
+ * The EXTi IRQ line 0 is shared with PMIC,
+ * so mark this as polled GPIO key.
+ */
+ button-2 {
+ label = "TA3-GPIO-C";
+ linux,code = <KEY_C>;
+ gpios = <&gpiog 0 GPIO_ACTIVE_LOW>;
+ };
};
gpio-keys {
@@ -59,13 +69,6 @@
wakeup-source;
};
- button-2 {
- label = "TA3-GPIO-C";
- linux,code = <KEY_C>;
- gpios = <&gpioi 11 GPIO_ACTIVE_LOW>;
- wakeup-source;
- };
-
button-3 {
label = "TA4-GPIO-D";
linux,code = <KEY_D>;
--
2.27.0
