The mhi_prepare_for_transfer() and mhi_unprepare_from_transfer() APIs could use better explanation, especially with the addition of two new APIs to start and stop the transfers on channels. Add better set of information for those APIs.
Signed-off-by: Bhaumik Bhatt <bbh...@codeaurora.org> --- include/linux/mhi.h | 26 ++++++++++++++++++++++++-- 1 file changed, 24 insertions(+), 2 deletions(-) diff --git a/include/linux/mhi.h b/include/linux/mhi.h index 35779a0..bd229da 100644 --- a/include/linux/mhi.h +++ b/include/linux/mhi.h @@ -692,13 +692,35 @@ int mhi_device_get_sync(struct mhi_device *mhi_dev); void mhi_device_put(struct mhi_device *mhi_dev); /** - * mhi_prepare_for_transfer - Setup channel for data transfer + * mhi_prepare_for_transfer - Setup UL and DL channels for data transfer. + * Allocate and initialize the channel context and + * also issue the START channel command to both + * channels. Channels can be started only if both + * host and device execution environments match and + * channels are in a DISABLED state. Calling the + * mhi_start_transfer() function is not required + * afterwards as channels are already started. This + * function also initializes the channel context + * whereas mhi_start_transfer() can only be used to + * issue the start channel command once the context + * is setup. * @mhi_dev: Device associated with the channels */ int mhi_prepare_for_transfer(struct mhi_device *mhi_dev); /** - * mhi_unprepare_from_transfer - Unprepare the channels + * mhi_unprepare_from_transfer - Reset UL and DL channels for data transfer. + * Issue the RESET channel command and let the + * device clean-up the context so no incoming + * transfers are seen on the host. Free memory + * associated with the context on host. If device + * is unresponsive, only perform a host side + * clean-up. Channels can be reset only if both + * host and device execution environments match + * and channels are in an ENABLED, STOPPED or + * SUSPENDED state. Calling mhi_stop_transfer() is + * not required before calling this function as it + * will only stop transfers, not reset channels. * @mhi_dev: Device associated with the channels */ void mhi_unprepare_from_transfer(struct mhi_device *mhi_dev); -- The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum, a Linux Foundation Collaborative Project
