From: Vivek Aknurwar <viv...@codeaurora.org>

Lucid 5LPE is a slightly different Lucid PLL with different offsets and
porgramming sequence so add support for these

Signed-off-by: Vivek Aknurwar <viv...@codeaurora.org>
Signed-off-by: Jeevan Shriram <jshri...@codeaurora.org>
[vkoul: rebase and tidy up for upstream]
Signed-off-by: Vinod Koul <vk...@kernel.org>
---
 drivers/clk/qcom/clk-alpha-pll.c | 223 +++++++++++++++++++++++++++++++
 drivers/clk/qcom/clk-alpha-pll.h |   4 +
 2 files changed, 227 insertions(+)

diff --git a/drivers/clk/qcom/clk-alpha-pll.c b/drivers/clk/qcom/clk-alpha-pll.c
index 564431130a76..6a399663d564 100644
--- a/drivers/clk/qcom/clk-alpha-pll.c
+++ b/drivers/clk/qcom/clk-alpha-pll.c
@@ -146,6 +146,12 @@ EXPORT_SYMBOL_GPL(clk_alpha_pll_regs);
 /* LUCID PLL specific settings and offsets */
 #define LUCID_PCAL_DONE                BIT(27)
 
+/* LUCID 5LPE PLL specific settings and offsets */
+#define LUCID_5LPE_PCAL_DONE           BIT(11)
+#define LUCID_5LPE_ENABLE_VOTE_RUN     BIT(21)
+#define LUCID_5LPE_PLL_LATCH_INPUT     BIT(14)
+#define LUCID_5LPE_ALPHA_PLL_ACK_LATCH BIT(13)
+
 #define pll_alpha_width(p)                                     \
                ((PLL_ALPHA_VAL_U(p) - PLL_ALPHA_VAL(p) == 4) ? \
                                 ALPHA_REG_BITWIDTH : ALPHA_REG_16BIT_WIDTH)
@@ -1561,3 +1567,220 @@ const struct clk_ops clk_alpha_pll_postdiv_lucid_ops = {
        .set_rate = clk_alpha_pll_postdiv_fabia_set_rate,
 };
 EXPORT_SYMBOL_GPL(clk_alpha_pll_postdiv_lucid_ops);
+
+static int alpha_pll_lucid_5lpe_enable(struct clk_hw *hw)
+{
+       struct clk_alpha_pll *pll = to_clk_alpha_pll(hw);
+       u32 val;
+       int ret;
+
+       ret = regmap_read(pll->clkr.regmap, PLL_USER_CTL(pll), &val);
+       if (ret)
+               return ret;
+
+       /* If in FSM mode, just vote for it */
+       if (val & LUCID_5LPE_ENABLE_VOTE_RUN) {
+               ret = clk_enable_regmap(hw);
+               if (ret)
+                       return ret;
+               return wait_for_pll_enable_lock(pll);
+       }
+
+       /* Check if PLL is already enabled */
+       ret = trion_pll_is_enabled(pll, pll->clkr.regmap);
+       if (ret < 0)
+               return ret;
+
+       ret = regmap_update_bits(pll->clkr.regmap, PLL_MODE(pll), PLL_RESET_N, 
PLL_RESET_N);
+       if (ret)
+               return ret;
+
+       /* Set operation mode to RUN */
+       regmap_write(pll->clkr.regmap, PLL_OPMODE(pll), PLL_RUN);
+
+       ret = wait_for_pll_enable_lock(pll);
+       if (ret)
+               return ret;
+
+       /* Enable the PLL outputs */
+       ret = regmap_update_bits(pll->clkr.regmap, PLL_USER_CTL(pll), 
PLL_OUT_MASK, PLL_OUT_MASK);
+       if (ret)
+               return ret;
+
+       /* Enable the global PLL outputs */
+       ret = regmap_update_bits(pll->clkr.regmap, PLL_MODE(pll), PLL_OUTCTRL, 
PLL_OUTCTRL);
+       if (ret)
+               return ret;
+
+       /* Ensure that the write above goes through before returning. */
+       mb();
+       return ret;
+}
+
+static void alpha_pll_lucid_5lpe_disable(struct clk_hw *hw)
+{
+       struct clk_alpha_pll *pll = to_clk_alpha_pll(hw);
+       u32 val;
+       int ret;
+
+       ret = regmap_read(pll->clkr.regmap, PLL_USER_CTL(pll), &val);
+       if (ret)
+               return;
+
+       /* If in FSM mode, just unvote it */
+       if (val & LUCID_5LPE_ENABLE_VOTE_RUN) {
+               clk_disable_regmap(hw);
+               return;
+       }
+
+       /* Disable the global PLL output */
+       ret = regmap_update_bits(pll->clkr.regmap, PLL_MODE(pll), PLL_OUTCTRL, 
0);
+       if (ret)
+               return;
+
+       /* Disable the PLL outputs */
+       ret = regmap_update_bits(pll->clkr.regmap, PLL_USER_CTL(pll), 
PLL_OUT_MASK, 0);
+       if (ret)
+               return;
+
+       /* Place the PLL mode in STANDBY */
+       regmap_write(pll->clkr.regmap, PLL_OPMODE(pll), PLL_STANDBY);
+}
+
+/*
+ * The Lucid 5LPE PLL requires a power-on self-calibration which happens
+ * when the PLL comes out of reset. Calibrate in case it is not completed.
+ */
+static int alpha_pll_lucid_5lpe_prepare(struct clk_hw *hw)
+{
+       struct clk_alpha_pll *pll = to_clk_alpha_pll(hw);
+       struct clk_hw *p;
+       u32 regval;
+       int ret;
+
+       /* Return early if calibration is not needed. */
+       regmap_read(pll->clkr.regmap, PLL_MODE(pll), &regval);
+       if (regval & LUCID_5LPE_PCAL_DONE)
+               return 0;
+
+       p = clk_hw_get_parent(hw);
+       if (!p)
+               return -EINVAL;
+
+       ret = alpha_pll_lucid_5lpe_enable(hw);
+       if (ret)
+               return ret;
+
+       alpha_pll_lucid_5lpe_disable(hw);
+
+       return 0;
+}
+
+static int alpha_pll_lucid_5lpe_set_rate(struct clk_hw *hw, unsigned long rate,
+                                        unsigned long prate)
+{
+       struct clk_alpha_pll *pll = to_clk_alpha_pll(hw);
+       unsigned long rrate;
+       u32 regval, l;
+       u64 a;
+       int ret;
+
+       rrate = alpha_pll_round_rate(rate, prate, &l, &a, 
ALPHA_REG_16BIT_WIDTH);
+
+       /*
+        * Due to a limited number of bits for fractional rate programming, the
+        * rounded up rate could be marginally higher than the requested rate.
+        */
+       if (rrate > (rate + PLL_RATE_MARGIN) || rrate < rate) {
+               pr_err("Call set rate on the PLL with rounded rates!\n");
+               return -EINVAL;
+       }
+
+       regmap_write(pll->clkr.regmap, PLL_L_VAL(pll), l);
+       regmap_write(pll->clkr.regmap, PLL_ALPHA_VAL(pll), a);
+
+       /* Latch the PLL input */
+       ret = regmap_update_bits(pll->clkr.regmap, PLL_MODE(pll),
+                                LUCID_5LPE_PLL_LATCH_INPUT, 
LUCID_5LPE_PLL_LATCH_INPUT);
+       if (ret)
+               return ret;
+
+       /* Wait for 2 reference cycles before checking the ACK bit. */
+       udelay(1);
+       regmap_read(pll->clkr.regmap, PLL_MODE(pll), &regval);
+       if (!(regval & LUCID_5LPE_ALPHA_PLL_ACK_LATCH)) {
+               pr_err("Lucid 5LPE PLL latch failed. Output may be 
unstable!\n");
+               return -EINVAL;
+       }
+
+       /* Return the latch input to 0 */
+       ret = regmap_update_bits(pll->clkr.regmap, PLL_MODE(pll), 
LUCID_5LPE_PLL_LATCH_INPUT, 0);
+       if (ret)
+               return ret;
+
+       if (clk_hw_is_enabled(hw)) {
+               ret = wait_for_pll_enable_lock(pll);
+               if (ret)
+                       return ret;
+       }
+
+       /* Wait for PLL output to stabilize */
+       udelay(100);
+       return 0;
+}
+
+static int clk_lucid_5lpe_pll_postdiv_set_rate(struct clk_hw *hw, unsigned 
long rate,
+                                              unsigned long parent_rate)
+{
+       struct clk_alpha_pll_postdiv *pll = to_clk_alpha_pll_postdiv(hw);
+       int i, val = 0, div, ret;
+
+       /*
+        * If the PLL is in FSM mode, then treat set_rate callback as a
+        * no-operation.
+        */
+       ret = regmap_read(pll->clkr.regmap, PLL_USER_CTL(pll), &val);
+       if (ret)
+               return ret;
+
+       if (val & LUCID_5LPE_ENABLE_VOTE_RUN)
+               return 0;
+
+       if (!pll->post_div_table) {
+               pr_err("Missing the post_div_table for the PLL\n");
+               return -EINVAL;
+       }
+
+       div = DIV_ROUND_UP_ULL((u64)parent_rate, rate);
+       for (i = 0; i < pll->num_post_div; i++) {
+               if (pll->post_div_table[i].div == div) {
+                       val = pll->post_div_table[i].val;
+                       break;
+               }
+       }
+
+       return regmap_update_bits(pll->clkr.regmap, PLL_USER_CTL(pll),
+                               (BIT(pll->width) - 1) << pll->post_div_shift,
+                               val << pll->post_div_shift);
+}
+
+const struct clk_ops clk_alpha_pll_lucid_5lpe_ops = {
+       .prepare = alpha_pll_lucid_5lpe_prepare,
+       .enable = alpha_pll_lucid_5lpe_enable,
+       .disable = alpha_pll_lucid_5lpe_disable,
+       .set_rate = alpha_pll_lucid_5lpe_set_rate,
+};
+EXPORT_SYMBOL_GPL(clk_alpha_pll_lucid_5lpe_ops);
+
+const struct clk_ops clk_alpha_pll_fixed_lucid_5lpe_ops = {
+       .enable = alpha_pll_lucid_5lpe_enable,
+       .disable = alpha_pll_lucid_5lpe_disable,
+};
+EXPORT_SYMBOL_GPL(clk_alpha_pll_fixed_lucid_5lpe_ops);
+
+const struct clk_ops clk_alpha_pll_postdiv_lucid_5lpe_ops = {
+       .recalc_rate = clk_alpha_pll_postdiv_fabia_recalc_rate,
+       .round_rate = clk_alpha_pll_postdiv_fabia_round_rate,
+       .set_rate = clk_lucid_5lpe_pll_postdiv_set_rate,
+};
+EXPORT_SYMBOL_GPL(clk_alpha_pll_postdiv_lucid_5lpe_ops);
diff --git a/drivers/clk/qcom/clk-alpha-pll.h b/drivers/clk/qcom/clk-alpha-pll.h
index d3201b87c0cd..d983b1aab8c8 100644
--- a/drivers/clk/qcom/clk-alpha-pll.h
+++ b/drivers/clk/qcom/clk-alpha-pll.h
@@ -142,6 +142,10 @@ extern const struct clk_ops clk_alpha_pll_lucid_ops;
 #define clk_alpha_pll_fixed_lucid_ops clk_alpha_pll_fixed_trion_ops
 extern const struct clk_ops clk_alpha_pll_postdiv_lucid_ops;
 
+extern const struct clk_ops clk_alpha_pll_lucid_5lpe_ops;
+extern const struct clk_ops clk_alpha_pll_fixed_lucid_5lpe_ops;
+extern const struct clk_ops clk_alpha_pll_postdiv_lucid_5lpe_ops;
+
 void clk_alpha_pll_configure(struct clk_alpha_pll *pll, struct regmap *regmap,
                             const struct alpha_pll_config *config);
 void clk_fabia_pll_configure(struct clk_alpha_pll *pll, struct regmap *regmap,
-- 
2.26.2

Reply via email to