This makes sure the clock tree setup for the dphy is not dependent on
other components.
Without this change bringing up the display can fail like
kernel: phy phy-30a00300.dphy.2: Invalid CM/CN/CO values: 165/217/1
kernel: phy phy-30a00300.dphy.2: for hs_clk/ref_clk=451656000/593999998 ~
165/217
if LCDIF doesn't set up that part of the clock tree first. This was
noticed when testing the Librem 5 devkit with defconfig. It doesn't
happen when modules are built in.
Signed-off-by: Guido Günther <a...@sigxcpu.org>
---
arch/arm64/boot/dts/freescale/imx8mq.dtsi | 11 ++++++++---
1 file changed, 8 insertions(+), 3 deletions(-)
diff --git a/arch/arm64/boot/dts/freescale/imx8mq.dtsi
b/arch/arm64/boot/dts/freescale/imx8mq.dtsi
index a841a023e8e0..ca0847e8f13c 100644
--- a/arch/arm64/boot/dts/freescale/imx8mq.dtsi
+++ b/arch/arm64/boot/dts/freescale/imx8mq.dtsi
@@ -1016,9 +1016,14 @@ dphy: dphy@30a00300 {
reg = <0x30a00300 0x100>;
clocks = <&clk IMX8MQ_CLK_DSI_PHY_REF>;
clock-names = "phy_ref";
- assigned-clocks = <&clk IMX8MQ_CLK_DSI_PHY_REF>;
- assigned-clock-parents = <&clk
IMX8MQ_VIDEO_PLL1_OUT>;
- assigned-clock-rates = <24000000>;
+ assigned-clocks = <&clk
IMX8MQ_VIDEO_PLL1_REF_SEL>,
+ <&clk
IMX8MQ_VIDEO_PLL1_BYPASS>,
+ <&clk IMX8MQ_CLK_DSI_PHY_REF>,
+ <&clk IMX8MQ_VIDEO_PLL1>;
+ assigned-clock-parents = <&clk IMX8MQ_CLK_25M>,
+ <&clk IMX8MQ_VIDEO_PLL1>,
+ <&clk IMX8MQ_VIDEO_PLL1_OUT>;
+ assigned-clock-rates = <0>, <0>, <24000000>;
#phy-cells = <0>;
power-domains = <&pgc_mipi>;
status = "disabled";
--
2.29.2
